User Guide

ManualsBrandsAudiovox ManualsOtherAPS20B

128-6186B

1 of 6

Released 11-5-01.

Model APS-20B

Owner's Manual

3 Button Vehicle Alarm System

With Auxiliary Output

FEATURES:

2 Three Button RF Transmitters

Three Channel Code Learning Receiver

Remote Panic In All Modes

Built-In Parking Light Output

LED Status Indicator

Multi-Tone Siren

True Last Door Arming

Channel 2 Auxiliary Output

OPTIONS:

Remote Trunk Release

Remote Power Window Control

Remote Garage Door Interface

Remote Engine Starter

Single or Dual Stage Shock Sensor

Starter Interrupt

Keyless Entry

Ignition Control Door-Locks

Page 1

Changed 1-23-02.(note: No Rev was Required)

Corrected 2-15-02.(note: No Rev was Required)

Revision A: 2-10-03 Changed reference to channel to Blue wire, Ch #2

Revision B: 3-5-03 Removed Channel # reference from title

Summary of content (6 pages)

PAGE 1
Model APS-20B Owner's Manual 3 Button Vehicle Alarm System With Auxiliary Output FEATURES: 2 Three Button RF Transmitters Three Channel Code Learning Receiver Remote Panic In All Modes Built-In Parking Light Output LED Status Indicator Multi-Tone Siren True Last Door Arming Channel 2 Auxiliary Output OPTIONS: Remote Trunk Release Remote Power Window Control Remote Garage Door Interface Remote Engine Starter Single or Dual Stage Shock Sensor Starter Interrupt Keyless Entry Ignition Control Door-Locks Pag
PAGE 2
Your APS-20B Vehicle Alarm System has many features and available options some of which must be selected at time of installation. For your reference, the list on the back page of this manual shows what features and options have been installed with this particular system. Consult your installing dealer for options that may have been installed and are not listed. ARMING THE SYSTEM - ACTIVE 1. Turn the engine off, exit the vehicle and close all doors. 2.
PAGE 3
detector to trigger the alarm when armed. If the optional 2-stage shock sensor is installed, any lesser impact will cause the pre-detect stage of the shock sensor to emit a series of short warning tones from the siren when armed. If the optional starter interrupt is installed the vehicle starter circuit is disabled, even with the ignition key the vehicle will not start. DISARMING THE SYSTEM As you approach the vehicle, press and release the unlock button on the keychain transmitter.
PAGE 4
To return to the normal, (alarm mode), operation, move the valet switch to the "off" position any time the ignition switch is in the on position. Note: In the event that you lose your keychain transmitter or the transmitter fails to operate the alarm system, the valet switch can be used to disarm the alarm. This is referred to as the "Manual Override". To disarm the alarm: 1. Open the door with the vehicle door key. (The siren will sound) 2. Turn the ignition switch to the "on" position. 3.
PAGE 5
This will cause the lights to flash, the siren to sound. The panic mode will continue for 30 seconds and then reset. To disengage the panic feature before the 30 seconds are up, press and hold the lock or unlock button of your keychain transmitter for 3 seconds. While the panic mode is engaged, the doors can be remotely locked and unlocked via the transmitter by pressing the lock or unlock button momentarily.
PAGE 6
SYSTEM FUNCTIONS AT A GLANCE ALARM LED INDICATORS: RAPID FLASHING = PASSIVE ARMING SLOW FLASHING = ARMED OFF = DISARMED ON SOLID = VALET MODE 2 FLASH...PAUSE = HOOD/TRUNK/SHOCK INTRUSION 3 FLASH...