Installation Manual
128-9312
9 of 24
9
9 Black w/ Red Trace Wire: Pulsed Ground Output After Shutdown
The Black w/ Red Trace wire will provide a 1 second 300 mA pulsed ground output 2 seconds after the remote
starts GWR wire shuts down. This output will occur regardless of whether the circuit times out or is manually
terminated. Typically this output will be used to re-lock the vehicle doors if the doors unlock automatically
when the ignition circuit transitions to off. This output is selectable and can function as described in feature
selection of Bank 3 feature #22.
10 Black w/ Blue Trace Wire: Pulsed Ground Output Before Start
The Black w/ Blue Trace Wire will provide a 1 second 300 mA pulsed ground output 500 mS before GWR
becomes active as well as when the transmitter is used to disarm the system. Typical use for this output
would be to disarm a factory theft deterrent system to prevent false triggering of the factory alarm when the
remote start unit engages or when the system is used to unlock the doors. This will also activate when the
transmitter is used to disarm/unlock the system.
NOTE: This output can be selected to operate like the door unlock output as set in alarm feature setting #1 by
selecting feature #19 in Bank 3 for 2 Chirps or any other pulse timing shown for that feature selection.
11 Black w/ Light Green Trace Wire: Pulsed Ground Output After Start
The Black w/ Light Green Trace wire will provide a 1 second 300mA pulsed ground output after the vehicle
is started under control of the remote start unit. Typically this wire will be used to re-lock the vehicle doors
if the doors unlock automatically when the factory anti-theft system is disarmed. This wire will also activate
when the transmitter is used to arm/lock the system. This output can be selected to operate in a number of
different congurations as shown in selectable feature # 21 of Bank 3.
12 Light Blue Wire: Ground Output While Running (-) 300mA
This wire provides a 300mA ground output that becomes active 1.5 seconds before the Remote Start Unit
initializes and remains grounded while running plus an additional 2 seconds after the Remote Start Unit
turns off. In all of the applications described below, a relay will be required.
The Light Blue wire can be used to accommodate the situations found on the following page.
13 Grey w/ Black Trace Wire: Negative Inhibit Input / Trigger When Armed
The Grey w/ Black Trace Wire provides an instant shutdown for the Remote Start Control Module whenever
it is grounded. Connect the Grey w/ Black Trace Wire to the hood pin switch previously installed. This wire
must be routed through a grommet in the rewall and connected to the hood pin switch. If connecting to a
factory hood pin switch, or separate alarm, it is recommended that a double diode circuit be used to prevent
feedback of one device to the other.
14 Black w/ White Trace Wire: 300 mA Horn Output
The Black w/ White Trace Wire is provided to beep the vehicle’s horn. This is a transistorized low current
output, and should only be connected to the low current ground output from the vehicle’s horn switch.
If the vehicle uses a +12 VDC horn switch, then connect the Black w/White Trace Wire to terminal 86 of a 30
Amp automotive relay, and connect relay terminal 85 to a fused +12 VDC battery source. Connect relay terminal
87 to the vehicle’s horn switch output, and connect relay terminal 30 to a fused +12 VDC battery source.