Installation manual

128-9300

8 of 24

3 Green Wire: Door Unlock (-) Output

The Green wire provides a (-) Negative Pulse when the transmitter is used, while the vehicle is running by

remote start, to unlock the doors. See Page 12-13 for use of this unlock output.

4 Brown w/ Black trace Wire: Positive Inhibit Input

The Brown w/ Black Trace wire provides an instant shutdown for the Remote Start Control module whenever

it gets + 12 volts. If the Brake lights switch in the vehicle switches + 12 volts to the brake light circuit, con-

nect the Brown w/ Black trace wire to the output side of the brake switch. This will allow the Remote Start

to shut down if an attempt is made to operate the vehicle without the key while running under the control

of the Remote Start. In most vehicles, in order to shift into gear, the brake pedal must be depressed. The

brake input will in turn cause the remote start unit to shut off.

5 Brown Wire: (+) Inhibit Shut Down

Any time + 12 Volts is applied to the Brown wire, the Remote Starter will be prevented from operating, even

if the signal is received from the transmitter. If there is a neutral start wire in the vehicle that switches + 12

volts when the vehicle is in any gear other than Park or Neutral, this wire can be connected to that vehicle

wire to prevent starting while in gear.

6 Gray: (-) Inhibit / Shut Down

Any time ground is applied to the Gray wire, the Remote Starter will be prevented from operating, even if

the signal is received from the transmitter. If there is a neutral start wire in the vehicle that switches ground

when the vehicle is in any gear other than Park or Neutral, this wire can be connected to that vehicle wire

to prevent starting while in gear.

If the vehicle you are working switches ground to the brake light circuit, this wire can be connected to the

output side of the brake switch. This will allow the Remote Start to shut down if an attempt is made to op-

erate the vehicle without the key while running under the control of the Remote Start. In most vehicles, in

order to shift into gear, the brake pedal must be depressed. The brake input will in turn cause the remote

start unit to shut off.

7 Black w/ Yellow trace Wire: Ground Output During Start (Crank)

The Black w/ Yellow Trace wire will provide a 300 mA ground output while the starter output of the remote

start unit is active. This output can be used to activate the Crank Low/Bulb Test wire found in some GM

vehicles. This wire is also referred to as the ECM wake up wire in some vehicles.

NOTE: The outputs above are low current outputs and must be used with a relay if the circuit's requirement

is more than 300 mA. This output is also selectable and can preform an alternate function as shown in

feature selection bank 3 Feature #20.

8 Black w/ Red trace Wire: Pulsed Ground Output After Shutdown

The Black w/ Red Trace wire will provide a 1 second 300 mA pulsed ground output 2 seconds after the

remote starts GWR wire shuts down. This output will occur regardless of whether the circuit times out or is

manually terminated. Typically this output will be used to re-lock the vehicle doors if the doors unlock auto-

matically when the ignition circuit transitions to off. This output is selectable and can function as described

in feature selection of bank 3 feature #22.