Installation Manual

INSTALLING THE MOUNTING BRACKET
13
Installing the Mounting Bracket
1� Once all the pre-wiring is complete, locate:
• Mounting Bracket
• (4) M4 x 15mm Self-Drilling Screws
2� Carefully align the Mounting Bracket in the location it is to be
installed (make sure there is nothing between the Mounting Bracket
and Roof Cross-Member)�
3� While holding the Mounting Bracket in place, install the
(4) M4 x 15mm Self-Drilling Screws�
CAUTION: Be sure that the Self-drilling Screws do not pierce the
outer roof skin when fully fastened to the Roof Cross-Member�
*Self-drilling Screws
Mounting Bracket
Headliner
Roof Cross-Member
Roof
(4 x Self Drilling
Screws - M4 x 15mm)
Mounting Bracket
*CAUTION: Use extreme caution when using the
Self-drilling Screws to avoid damage to vehicle
roof or other components, wiring, etc.
Front
of
Vehicle
NOTE: In some vehicles the headliner may need to be cut to install the mounting bracket properly. Use caution to avoid cutting wires above or
attached to the headliner.