AVXMTGHR1D 7” LCD MONITOR WITH BUILT-IN DVD PLAYER FOR REAR SEAT ENTERTAINMENT PUSH OPERATION MANUAL / INSTALLATION GUIDE 128-8944B
Important Notice Installation of headrest products require careful planning and preparation. Be extremely careful of seats that have airbags built into them. Keep wiring away from any air bag wiring (usually identified by yellow connectors and yellow wire jackets). Damage to air bag wiring can result in personal injury to vehicle occupants. If you have any questions regarding wire routing or installation in a vehicle, please contact Audiovox Technical Support at 1-800-225-6074.
FEATURES • 7” Digital Thin Film Transistor (TFT) Active Matrix Liquid Crystal Display (LCD) Monitor • Built-in DVD Player • Last position memory for DVD player • Three Audio / Video Source inputs (DVD, AV and AUX) • USB 2.
MATERIAL TO USE IN THIS PACKAGE: 1) AVXMTGHR1D System Monitor with DVD Player (AVXMTGHR1D) (1pc) NOTE: The AVXMTGHR1D monitor has been designed to be interchangeable from one headrest to the other. The headrests will still have the Green and Red Din cables on them and should be connected to their respective connectors. The headrest cover from the manufacturer is covered with shale colored vinyl. PUSH NOTE: Headrest cables are included with the headrest DVD player and the headrest monitor.
HEADREST COVER REPLACEMENT: NOTE: If desired, replace the headrest cover before installing the headrest in the vehicle. 1. Using a Philips screwdriver, unscrew the two Philips screws and lift the bottom edge of the monitor upward. Unscrew Philips Screws 2. Remove the velcro tabs securing the headrest cover. Remove Velcro Tabs 3. Replace the headrest cover with the desired color and secure the headrest cover by re-attaching the velcro tabs. 4.
VEHICLE PREPARATION 1) Decide on the system configuration and the options that will be installed. 2) Read the manuals and get familiar with the electrical requirements and connections. 3) Decide on the mounting locations and methods of mounting the products that will be connected to the AVXMTGHR1D. 4) Prepare the vehicle by removing any interior trim necessary to gain access to the vehicle's wiring as well as all areas where interconnecting wire harnesses will be located.
8) Install the headrests: a. Remove vehicle's original headrests. b. insert appropriate support tube adaptors in vehicle post guides. (if needed) c. Hold the headrest above the seat and insert the two cables into the vehicle support guides Make sure that the headrest is in the correct position (Display facing the rear). d. Route the cables through the seat back and out the bottom of the seat while pulling the cables to remove the slack.
AVXMTGHR1D WIRING DIAGRAM Headrest Monitor PUSH RED 12V+VDC GroundVideo In Yellow Audio In Right Red GREEN Video Out Yellow Audio Out Right Red Audio Out Left White Audio In Left White 8 Pin (M) Din Cable Red with RCA Cable (P/N 112-4149)-(1pc) 8 8 Pin (M) Din Cable Green with RCA Cable (P/N 112-4160)-(1pc) AVXMTGHR1D
AVXMTGHR1D CONTROLS AND INDICATORS DIAGRAM (FRONT VIEW) LCD PANEL PUSH POWER/SOURCE VOLUME /NEXT PLAY/PAUSE SYSTEM MENU VOLUME /PREVIOUS STOP SCREEN RELEASE IR SENSOR PULL DOWN IR HEADPHONE TRANSMITTER LENS HEADPHONE JACK AUX IN JACK AUX IN SD USB PHONE SD CARD READER USB PORT COVER (BOTTOM VIEW) DVD DISC PUSH (FRONT VIEW MONITOR OPEN) AVXMTGHR1D 9
REMOTE CONTROL OPERATION NOTE: The remote control has a battery installed with a pull tab to prevent battery discharge. Remove the pull tab before attempting to use the remote. Battery Replacement 1. Remove the battery holder. 2. Insert the battery (CR2025) into the battery holder and insert the battery holder into the remote. Be sure to observe the correct polarity. 3. Align the battery holder with the remote control and push until the holder clicks.
* Function control is available on the unit and the remote control. 1. POWER ( ) Button* Press this button to turn the unit ON and OFF. 2. SOURCE Button* Each time the button is pressed, the audio / video source will change in the following sequence: DVD > AV > AUX NOTE: The USB device and the SD card can be accessed using the DVD source button. Refer to Item 26. MUTE Button Press this button to mute all the audio. Pressing the button again restores the sound to the previously set level. 4.
10. ZOOM Button Press this button to enlarge or decrease the picture size when playing a DVD disc. Press ZOOM button DVD Player performs Once Enlarges the picture 2X Twice Enlarges the picture 3X 3 Times Enlarges the picture 4X 4 Times Reduces the picture 1/2 5 Times Reduces the picture 1/3 6 Times Reduces the picture 1/4 7 Times Picture is returned to original size 11.
19. FF SCAN FORWARD (8) Button* Press to search in the forward direction. Press repeatedly to change the search speed from 2, 4, 8, 16 and 32 times the normal speed. 20. STOP (n) Button* Press to stop playback. 21. NEXT (:) Button* Press to skip to the next chapter or track. 22. PAUSE ( II ) Button* Allows the user to pause the playback. Pressing pause again or pressing the Play button will resume normal playback. 23. ENTER Button Used to implement a selected setting or menu option. 24.
MENU ADJUSTMENT The System Menu contains features and options that allow you to customize your system. 1) Press the “ ” button on unit or press the TV button and the SYSTEM MENU button on the remote control, the menu display below will appear on screen. Use the “+” “-” buttons to change the setting . To select the next menu press the “ ” button or the SYSTEM MENU button on the remote control. 2) 3) MENU DISPLAY The first adjustment to appear is the volume adjustment.
The FM Modulator adjustments consist of turning the FM Modulator on or off and selecting the FM Modulator frequency. The wireless FM Modulator Frequencies that can be selected are: (CH1 87.7MHz, CH2 88.1MHz, CH3 88.5MHz, CH4 88.9MHz, CH5 106.7MHz, CH6 107.1MHz, CH7 107.5MHz, CH8 107.9MHz. FMM OFF The OSD Language feature allows the user to select the language for the onscreen display. The user can either select English, Dutch, French, Spanish, Russian or Chinese for the OSD language.
GENERAL PAGE General Audio Preference General Setup Page TV Display Wide Screen Saver On On Last Memory Exit Goto General Setup Page TV Display The TV Display feature allows the user to change the screen format (aspect ratio to 4:3 PScan, 4:3 LB, or 16:9 Wide). 1. To select the screen aspect ratio mode use the cursor button p or q to highlight TV DISPLAY. Press the cursor button u to open the sub menu that contains the different options available.
AUDIO SETUP PAGE General Audio Preference Audio Setup Page Equalizer None Sound Mode Bass Boost Off Super Bass Off Treble Boost Off Exit Goto Audio Setup Page Sound Mode The sound mode feature allows the user to apply preset sound effects to the unit’s audio output signal. The user may choose from: None ,Rock, Pop, Live, Dance, Techno, Classic and Soft. 1. To select the sound mode use the cursor button p or q to highlight SOUND MODE.
PREFERENCE PAGE General Audio Preference Preference Page TV Type NTSC Audio Eng Subtitle Eng Disc Menu Eng Parental Password Default Exit Goto Preference Page NOTE: This menu page available if there is no disc in the disc tray, the disc tray is open or the disc in the disc tray is stopped. There are seven items in the PREFERENCE PAGE. They are TV TYPE, AUDIO, SUBTITLE, DISC MENU, PARENTAL, PASSWORD, and DEFAULT. The Preference page can only be accessed when the disc compartment is empty.
Audio Menu This item allows a user to select a preferred audio language. This function only applies to discs encoded with different audio languages. Options: English, French, Spanish, Chinese, Japanese, Korean, Russian, and Thai. NOTE: If the selected language is not available for the currently playing disc, the disc's default setting is applied. 1. To select the audio feature use the cursor button p or q to highlight AUDIO.
Parental This item allows the user to limit the content of movie playback from Kid Safe to Adult. The lower the value, the more strict the control. Movies rated higher than the level set for the parental lock can not be viewed without entering the correct password. Options: 1 G 2 PG 3 PG – 13 4 R 5 NC17 6 Adult NOTE: The rating level can be changed only when the correct password is provided. This function only works with those discs with parental function. 1.
EXIT SETUP PAGE General Audio Video Setup Page Preference Exit Exit Setup Menu Exit Setup Page The exit setup page allows the user to exit the setup menu and return to the DVD playback. 1. To exit the setup page use the u to highlight EXIT and press ENTER to confirm the selection. Playing DVDs Press the DISPLAY button on the remote control to display the status banner. The banner includes disc title, chapter, and elapsed time.
Note: The System supports: Files: MP3 and JPEG files only. File systems: FAT16 and FAT32 The system will NOT support: Files: BMP, M4P, WAV, ASF, H.264, DivX, WMA File systems: NTFS, ExFAT The system will always default to the DVD when the system detects a disc in the DVD player. Playing Audio CDs When playing an audio CD, the DISPLAY banner appears automatically. The track number and the elapsed time of the disc are displayed.
Selecting Folders and Songs When an MP3 disc is loaded in the player, the navigation menu will appear on the screen automatically. Press the cursor button, or , to move the highlight to the desired folder and press the ENTER button to display the songs in the folder. Press the cursor button, or , to move the highlight to the desired song and press the ENTER button to begin playback of the highlighted song. Selecting a Play Mode You can choose what order the songs will play on a disc temporarily.
DVD Basics To get the optimum use out of the DVD Player, please read the following:. DVD Region Code The DVD player is preset to a region code at the factory depending on where the DVD player is sold. A DVD from a different region cannot be played in this unit and the unit will display "WRONG REGION”. Region 1- USA, Canada Region 2- Japan, Europe, South Africa, Middle East, Greenland Region 3- S.
TROUBLESHOOTING PROBLEM SOLUTION IR remote inoperative • Verify that the battery in the remote is fresh. • Verify that the remote sensor eye is not obstructed. Disc won't play • Insert a disc with the label side facing upwards. • Check the type of disc you put into disc tray. This DVD only plays DVD, audio CD and MP3s. • Both the unit and the disc are coded by region. If the Play starts, but then stops immediately • The disc is dirty. Clean it. • Condensation has formed. Allow player to dry out.
Applies to Movies To Go Mobile Video Products AUDIOVOX ELECTRONICS CORP. (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workman ship within 12 months from the date of original purchase, such defect(s) will be repaired or replaced with reconditioned product (at the Company's option) without charge for parts and repair labor.
NOTES
© 2011 Audiovox Electronics Corp.
