User manual
7
Pairing the stereo headset with a Bluetooth® cell phone
Prior to using the headset for the rst time, you have to pair it with a Bluetooth® capable cell phone.
The pairing procedures can dier between cell phone models and manufacturers. Please refer to
your cell phone user’s manual for further information. The general pairing procedures are as follows:
1. Place the stereo headset and Bluetooth® cell phone approximately three feet apart without
physical obstructions such as walls etc.
2. Enter the headset’s pairing mode (please refer to Entering pairing mode).
3. Activate your cell phone’s Bluetooth® function and set your cell phone to search for Bluetooth®
devices.
4. Select BT-HP1 from the list of devices shown on the cell phone.
5. If and when prompted enter password or PIN “0000”.
6. If prompted by your cell phone to connect, accept the prompt “Yes” (this will vary among cell
phone models).
7. Once the stereo headphones and the cell phone have paired, the blue LED ashes twice or
three times every 4 seconds.
Note: If the pairing process fails, turn o the headset rst and repeat steps 1 through 6 above.
After pairing is successful, the headset and the cell phone will remember each other, and will not
require pairing again. The headset can remember up to 8 paired devices. When the number of
paired devices exceeds 8, the rst one will be removed and replaced.
Every time the headset is turned on, it will connect to last connected device automatically. If you
want to pair it with another device, please turn o the Bluetooth® function of the last connected
devices rst. Pair the headset with the new device according to steps 1 through 6 above.