Owner's Manual
Table Of Contents
- Installation Guide / User Manual
- Bluetooth PIN (0000)
- Table of Contents
- Supplied Accessories
- DIP Switch Settings
- Vehicle BUS Connector
- Attention Installer
- Connection Diagram - Bluetooth and AUX Inputs
- Connection Diagram - Bluetooth and Satellite Inputs
- Installation
- Controls and Indicators
- Bluetooth / AUX Operation
- Satellite Radio Operation
- Pairing Your Phone
- Operation
- AUX Audio Source (Optional)
- Optional Remote Kit
- Troubleshooting
- Updating Firmware
- Warranty
18
Pairing Your Phone
Your mobile phone can initiate a search for the BCS1M.
Note: The following procedures are generic. Procedures for pairing mobile phones may vary. Please
refer to the manual that came with your mobile phone.
1. Turn the BCS1M on and slide the button slider up to the
(Bluetooth) position.
2. Access the mobile phone’s Bluetooth function and turn the function on.
3. Set the mobile phone’s Bluetooth discover mode to on.
4. Use the mobile phone’s add new device feature. “Bluetooth car kit” will appear on your mobile
phone’s device list.
5. A prompt to pair should appear on your mobile phone. Accept the request to initiate the process.
6. Some mobile phones require a PIN to connect. If asked, enter “0000”.
7. A message stating that pairing is successful should appear on your mobile phone. A prompt
asking you to connect should also appear. Accept the request to initiate the connection.
8. Once connected, the light bar will turn a solid blue.
The light bar will flash red and blue alternatively.