Owner's Manual
Table Of Contents
- Installation Guide / User Manual
- Bluetooth PIN (0000)
- Table of Contents
- Supplied Accessories
- DIP Switch Settings
- Vehicle BUS Connector
- Attention Installer
- Connection Diagram - Bluetooth and AUX Inputs
- Connection Diagram - Bluetooth and Satellite Inputs
- Installation
- Controls & Indicators
- Bluetooth / AUX Operation
- Satellite Operation
- Important Installation Note
- Pairing Your Phone
- Operation
- Troubleshooting
- Updating Firmware
- Warranty
7
DIP switch settings
The following DIP switch settings are used to
configure the CarStream module to interface with
the various radio systems. Before installation, set
the DIP switch to the position shown for the
corresponding radios and desired features.
Use this setting if car is
equipped with base VW
radio or AUDI concert radio.
VW/ AUDI CONCERT
OFF
OFF
AUDI SYMPHONY
Use this settig if car is
equipped with Audi
Symphony radio system
ON
OFF
AUDI NAV+
Use this setting if car is
equipped with AUDI Navi-
gation plus radio system.
ON ON
VW NAV
Use setting if car is
equipped with Volkswagen
Navigation system.
OFF
ON
CarStream module