Installation Manual

ManualsBrandsAudiovox ManualsBlu-ray/DVD PlayerAudiovox CADNAV1

CADNAV1 Advent Integrated Navigation

This interface is designed to integrate Navigation into select

Cadillac CUE, Buick, Chevrolet and GMC MyLink Systems.

This system is NOT applicable to vehicles that do not have

CUE or MyLink/Intelilink and will not operate in those

vehicles.

INSTALLATION GUIDE

What’s in the Box

The following items are supplied with the CADNAV1

• LVDS Video Cable

#31414170

• Aux Audio # 31514170

• CAN Module #33814170

• GPS Antenna #34914170

• CAD Power Harness #37514170 • USB Update Cable #32714170

• Buick Power Harness #37614170 • Map SD Card #35014170

• CAN to NAV

#30314170 • Speaker Wire Harness #31914170

• Switch

#34714170 • AUX Video #33914170

• Installation Guide

• External Speaker #33514190

NOTE: Not all parts are used in every installation.

Summary of content (8 pages)

PAGE 1
CADNAV1 Advent Integrated Navigation This interface is designed to integrate Navigation into select Cadillac CUE, Buick, Chevrolet and GMC MyLink Systems. This system is NOT applicable to vehicles that do not have CUE or MyLink/Intelilink and will not operate in those vehicles.
PAGE 2
Prior to Installation: Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this accessory should follow approved guidelines to ensure a quality installation. Read entire instructions thoroughly before starting. This document covers such items as:• Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.). • Vehicle Disassembly/Reassembly (panel removal, part storage, etc.).
PAGE 3
Installation: Removal of the Radio control center is required for installation. Vehicle Specific instructions are available on-line at www. voxxuniversity.com. After the components are removed, connect the following: 1. The navigation module can be located behind the radio or to either side. Determine your exact mounting location to insure you route your wires correctly. 2. Using the supplied T-harness power cable, disconnect the matching cable from the rear of the main radio unit.
PAGE 4
9. USB Update Cable: This is used for map updates. Route the cable from the module to the glove box for future use as needed. Connect to the Nav module. 10. GPS Antenna: The antenna must be mounted in a location where it has a clear view of the sky. Center of the dash by the glass is recommended. NOTE: If reception is poor re-locate to another area and re-test. The GPS antenna cannot be blocked by metal surfaces and should be visible for best reception. 11.
PAGE 5
Navigation Interface Operation: CUE Equipped Vehicles: To change the OEM radio to Navigation mode press the Navigation icon on the main screen. Exit Navigation by pressing the home key on the radio face (see circled area). The nav will continue to operate unless you have selected to stop the route or used the Navigation Exit icon in the Nav application. MyLink Equipped Vehicles: If you have installed the switch, the NAV will be selected by pressing each time to enter or exit the Nav application.
PAGE 6
For Navigation operation see the included quick start guide or download a full user’s manual from WWW.ADVENTPRODUCTS.COM . If the picture is not centered or does not fill the screen correctly you can adjust the picture size. Access the settings menu by pressing the Menu button on the side of the Nav Interface Module. Use the Menu button to scroll through the options and “+” or “-” buttons to adjust the value. 1. 2. 3. 4. Contrast, Brightness and Saturation are all screen adjustments for picture quality.
PAGE 7
Vehicle Specific Instructions, Tech Tips, and Installation notes can be found at WWW.AUDIOVOXUNIVERSITY.
PAGE 8
Voxx Electronics Corporation Hauppauge, NY 11788 Technical Assistance: 1-800-323-4815 WWW.ADVENTPRODUCTS.COM .