SHUTTLE Vehicle Installation Guides SIR-CK1 and SIR- CK2 128-6813 1 of 14
Congratulations You are one step closer to experiencing Sirius Satellite Radio. Sirius will revolutionize your in-home or vehicle entertainment with: · 100 streams of original programming, including – 60 streams of completely commercial-free music – guaranteed.
Cautions and Warnings 1. Do not install the Shuttle in a position that hinders your view through the windshield, or obstructs view ing of the dashboard indicators and displays. 2. Do not install the unit where it may obstruct the operation or deployment of safety devices, such as airbags, etc. 3. Do not allow operation of the unit to detract from safe driving practices; remember that you are responsible as the vehicle operator to adhere to all safe driving and traffic regulations. 4.
Contents SIR-CK1 and SIR-CK2 Install Manual Base P/N 1286813 P/N 136C3484 HARDWARE KIT - P/N 150-1519 Audio Cable P/N 112B3293 Split Lock Washer, M4 1 pc. Antenna P/N 118C1126 1 pc. 1 pc. 4 pcs Cradle CK1 P/N 136D3471 or Cradle CK2 P/N 136D3479 1 pc. 4 pcs. 3/4” W X 3”Long Double Sided Tape Flat Washer, M4 1 pc 4 pcs. Alcohol Swab DC Power Adapter Phillips Machine Screw (M4 x 8mm) OPTIONAL FM Switching Box Assy P/N 112C3159 (6 Meter) P/N 112B3294 1 pc. 1 pc. 1 pc. 1 pc.
Installation/Wiring Precautions 1. To prevent a short-circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation. Connect power wires last. 2. Do not install the unit in the locations exposed to direct sunlight or, in areas subject to extreme temperatures. 3. Incorrect installation may cause damage to the system. Mount the unit firmly in place, using the supplied hardware. 4. Be careful not to damage the vehicle wiring. 5.
Interconnect Diagram FM Option Interconnect Diagram AUDIO CABLE SHUTTLE CRADLE CK1 OR CK2 FM FREQUENCY SELECTION SWITCH. SELECT 1 OF 4 AVAILABLE FREQUENCIES AND SET YOUR EXISTING CAR RADIO TO THE SAME FREQUENCY. VEHICLE RADIO ANTENNA VEHICLE FM RADIO SHUTTLE CRADLE CK1 ONLY TO AUXILIARY AUDIO INPUT OF RADIO OR ENTERTAINMENT SYSTEM ** OR DC POWER ADAPTER TO VEHICLE +12 VDC POWER RECEPTACLE ** TO VEHICLE +12 VDC POWER RECEPTACLE OR NOTE: SHUTTLE ANTENNA DC POWER ADAPTER SHUTTLE ANTENNA 1.
CAUTION: NOTE: Do not install the mounting base on a leather or fabric surface, or in a position that could impair your vision, block air bag(s) or obstruct vehicle dashboard controls and/or radio CD/casette operational displays. The adhesive backing on the base will not permit easy repositioning once it has been mated to the surface; use extreme care and planning when selecting the mounting location.
f. h. If the outside air temperature is cold, it may be beneficial to warm the adhesive backing on the base using a portable hair dryer, or by holding the backing surface in front of a vehicle heater vent. Insert the end of the ball strut into the keyed opening on the cradle mounting plate, and secure the plate to the ball strut using the flatwasher, lockwasher and flat-head screw through the back of the plate. g.
NOTE: Allow a 72-hour period for the adhesive backing to cure completely. k. Using the star nut, attach the cradle assembly to the base threaded socket; do not overtighten the star nut. 3. Installing the Cradle Using Double-Sided Tape You can mount the cradle directly to your dashboard or other flat surface without using the cradle mount in the kit. To do this, do not remove either of the mounting plate assemblies from the cradle. a. Remove the 3/4” x 3” double-sided tape from the supplied kit. b.
TOP RETAINING CLIP SAT. (MAIN) RF CONNECTOR BOTTOM LEFT SLIDE CLIP 16-PIN SYSTEM CONNECTOR TERR. RF CONNECTOR BOTTOM RIGHT SLIDE CLIP 6. Sirius Program Listening Options The Shuttle and Cradle provide an audio output signal in three manners: 1. When using CK1 or CK2 cradle, the audio signal can be routed through an audio cable which is applied to the auxiliary inputs of a radio or entertainment system. 2.
7. Mounting the Vehicle Antenna The antenna should be placed on a relatively flat surface on the vehicle exterior, preferably on the roof (high point) or on the trunk (convertible). To mount the antenna: SHUTTLE (TYPICAL) a. Plug the antenna into the SAT. (MAIN) connector on the back of the cradle. b. Place the antenna at the preferred location on the roof or trunk surface. If the vehicle is equipped with a roof or trunk rack, the antenna may have to be mounted off-center on the surface.
e. Plan the routing of the antenna cable to the Shuttle RF input. Make sure you avoid any obstructions that could crimp, kink or twist the cable; use protective grommets wherever rough openings are encountered. f. Route the cable from the antenna position to the interior of the vehicle, working the cable under the rear window molding; make adjustments and take up slack whenever necessary. g.
i. Plug the antenna cable into the SAT (MAIN) connector on the back of the cradle; then plug the cigarette lighter adapter into the lighter receptacle. The integral power LED of the power button ( ) will light red. j. You are now ready to enjoy Sirius programming within your vehicle. CAUTION: You could drain the vehicle battery if the cigarette lighter adapter remains plugged in after the ignition is turned off. Unplug the adapter to prevent this possibility.
12 MONTH LIMITED WARRANTY AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor.
