Service manual

Installing the Audiovox CCS100 Cruise Control on the
Honda Pacific Coast PC800 Motorcycle
Page 16
Copyright © 2001-2006 by Bruce Pickett. Copying or printing for personal use is permitted. All other rights reserved. January 21, 2006
It is important to avoid tight bends in the actuator cable. The cable has more length than is
needed, so it must be routed in such a fashion as to use up some of its length. As the actuator
cable leaves the back of the servo, route the cable downward behind the left side body panel.
Make certain that the cable will not interfere with the air duct/maintenance lid. Curve the cable
back up toward the fuel filler box.
Finally, attach the vacuum line from the vacuum canister to the port on the side of the servo.
Make sure that all vacuum connections are well sealed!