Service manual

Installing the Audiovox CCS100 Cruise Control on the
Honda Pacific Coast PC800 Motorcycle
Page 29
Copyright © 2001-2006 by Bruce Pickett. Copying or printing for personal use is permitted. All other rights reserved. January 21, 2006
Afterwards
Reactivate the electrical system.
Replace the body parts.
Test ride.
Each time the ignition switch or the cruise control switch is turned OFF, the system is
deenergized. To reenergize the system, the ignition switch must be turned on, and the cruise
control switch must be moved to the ON position. The cruise control switch can be left ON at all
times without causing any damage to the system.
ON/OFF
Move the ON/OFF switch to the ON position. The light in the center of the cruise control switch
will illuminate. This prepares the system for operation.
SET SPEED
After turning the system ON, wait at least 3 seconds before attempting to set your speed. To
operate the system, drive the vehicle at a steady speed above 35 mph. Press the SET/COAST
switch and release it, then slowly relax the throttle. Your SET SPEED is now programmed into
the cruise control's memory, and your driving speed should remain within 2 mph of your set
speed. If you want to increase your speed, simply advance the throttle. When you release the
throttle, you will return to your original SET SPEED.
ACCEL
You can increase you SET SPEED using the RESUME/ACCEL feature. Your vehicle will
accelerate as you hold this switch to the RESUME/ACCEL position. When you release the
switch, your SET SPEED will be reprogrammed to the present speed of the vehicle. You can also
increase your SET SPEED gradually by quickly pressing and releasing the RESUME/ACCEL
switch; each time you press and release the switch, your speed will increase by approximately
1/2 mph.
COAST
To reduce your SET SPEED, press and hold the SET/ COAST button. This erases the previously
programmed SET SPEED, and allows the vehicle to coast. Just before slowing to the speed you
want, release the button. Your present speed will be reprogrammed as the new SET SPEED,
providing the vehicle is traveling faster than 35 mph. You can also decrease your SET SPEED
gradually by quickly pressing and releasing the SET/ COAST switch. Each time you press and
release the switch, your speed will decrease by approximately 1/2 mph.