User Guide

PRECAUTIONS
Follow the advice below for safe and appropriate operations.
ON AC VOLTAGE
• Before use, check that the rated
voltage of your unit matches your
local voltage.
ON CONDENSATION
• When left in a heated room where
it is warm and damp, water
droplets or condensation may
form inside the CD player.
• When there is condensation
inside the unit, the unit may not
function normally.
• Let it stand for 1 to 2 hours before
turning the power on, or gradually
heat the room up and dry the unit
before use.
PARTS IDENTIFICATION
ON PLACEMENT
• Do not use the unit in places which
are extremely hot, cold, dusty, or
humid.
• Place the unit on a flat and even
surface.
• Do not restrict the air flow of the
unit by placing it in a place with
poor air flow, by covering it with a
cloth, or by placing it on a carpet.
ON SAFETY
• When connecting and
disconnecting the AC cord, grip
the plug and not the cord itself.
Pulling the cord may damage it
and create hazard.
• When you are not going to use the
unit for a long period of time,
disconnect the AC power cord.
1. Set the FUNCTION switch to
TUNER.
LISTENING TO THE RADIO
3. Tune into the desired station.
COMPACT DISC PLAYBACK
2. Slide the BAND selector to
choose AM(MW) or FM.
4. Adjust the desired sound.
1. FM STEREO/PROGRAM
indicator
2. POWER indicator
3. REMOTE SENSOR
4. CD PLAY/PAUSE indicator
5. FUNCTION selector
6. Cassette door
7. Cassette operation buttons
RECORD
PLAY
REWIND
F.FWD (Fast Forward)
STOP/EJECT
PAUSE
8. VOLUME control
9. PHONES jack
10. CD door
11. CD PLAY/PAUSE button
12. CD STOP button
13. Forward Skip +
14. Reverse Skip -
15. PROGRAM button
16. BAND selector (AM/FM)
17. TUNING control
18. Dial scale
19. AC cord
20. FM antenna wire
21. Speaker terminals
TUNING
VOLUME
SYSTEM CONNECTIONS
IMPORTANT
Switch off the power before connecting speakers and other equipment.
SPEAKER CORD CONNECTION
Connect the wires with the printed
white lines to the red (+) terminals
and the plain-black wires to the
black (-) terminals.
Warning:
Connecting speakers other than
the speakers supplied with the
unit, may damage the unit.
SPEAKER TERMINALS
IMPEDANCE : 8 OHM (Ω)
2. Open the CD door. Place a
disc in the center with the label
side up and then close the CD
door gently. The total number
of tracks will show in the
display.
FOR BETTER RECEPTION
FM
AM(MW)
Fully unwind the wire antenna. Then
extend the wire antenna and place
it in the position that sounds best.
NOTE: DO NOT CONNECT TO AN
OUTSIDE ANTENNA.
Repositioning the unit to get better
AM(MW) reception.
TO RECEIVE THE FM BROADCAST IN STEREO
Set the BAND selector to FM STEREO.
When the FM stereo broadcast is received, FM STEREO indicator lights up.
IF THE FM BROADCAST SIGNAL IS WEAK
Set the BAND selector to FM position to turn off the FM STEREO indicator
and background noises becomes mono.
AFTER LISTENING
Set the FUNCTION switch to TAPE/POWER OFF.
Should any trouble occur, disconnect the AC power cord and refer
servicing to qualified personnel.
USING HOUSE CURRENT
Before use, check that the rated
voltage of your unit matches your
local voltage.
2
1
AC cord to an
AC outlet
RIGHT
SPEAKER
BOX
LEFT
SPEAKER
BOX
POWER INDICATOR
While the AC cord is connected:
• The POWER indicator will light up when the FUNCTION switch is set to CD
or TUNER.
• When the FUNCTION switch is set to TAPE/POWER OFF, the POWER
indicator will be switched off.
After using the unit, set the FUNCTION switch to TAPE/POWER OFF.
ADJUSTING THE SOUND
TO ADJUST THE VOLUME
Adjust the VOLUME control to obtain the desired volume level.
WHEN RECORDING
The VOLUME control may be adjusted with no effect on the recorded signal.
FOR PRIVATE LISTENING
Connect headphones (ø3.5mm stereo mini-plug) to the PHONES jack.
When the headphones is connected, speakers are automatically
disconnected.
TO STOP PLAYBACK
Press the STOP button.
TO INTERRUPT PLAYBACK
Press the PLAY/PAUSE button. The PLAY/PAUSE indicator will blink.
To resume playback, press the PLAY/PAUSE button again.
3. Press the PLAY/PAUSE button. The PLAY/PAUSE indicator will light
up. Adjust the VOLUME.
COMPACT DISC PLAYBACK (continued)
COMPACT DISC PROGRAMMABLE PLAYBACK
1. Press the PROGRAM button.
3. Press the PROGRAM button.
2. Press the - SKIP +
buttons until the desired track
appears on the CD display.
4. Press steps 2 and 3 until all the
desired tracks are programmed
(up to 16 tracks).
5. Press the PLAY / PAUSE
button.
'


FCC INFORMATION
This device complies with Part 15 of FCC Rules. Operations are subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesirable operations.
Caution: To prevent electrical
shock, match wide blade of
plug to wide slot, fully insert.
1. Set the FUNCTION switch to
CD. " " is shown in the
display.
TO SEARCH THROUGH TRACKS
• Search function is possible only in playback mode.
• Keep press either one of the ( / ) SKIP
buttons according to the desired direction, and
release at the desired point.
TO SKIP TO THE BEGINNING OF A TRACK
• Press either one of the ( / ) SKIP buttons
according to the desired direction, each press
skips one track.
• Playback resumes from the selected track.
Keep it pressed during play
Each press skips one track
NOTE :
Programming can only be done when the unit is in the stop mode.
1
2
3
OU
OU
PROGRAM /
PROGRAM
OU
PROGRAM /
PROGRAM