PROTOCOL INTERFACE ADAPTER and XM DIRECT 2 TUNER CNP2000UCA "Compatible with Select Satellite Ready Car Stereos" Installation Guide
Table of Contents Table of Contents 2 Introduction &Installation Overview 3 Insta Ilation Basics..... t.
Introduction & Installation Overview Thank you for purchasing the AUDIOVOX Protocol Interface Adapter for satellite radio ready car stereo head units. The Protocol Interface Adapter allows you to adapt a satellite radio ready car stereo to receive XM Satellite Radio service. The PIA is easy to install plugging directly into the car stereo head unit*. The illustration below shows the installation of the XM Direct system, including the XM Direct 2 Tuner and the antenna.
Installation Basics Note: Before installation, your PIA must have the proper radio model protocol downloaded. Please see an authorized dealer for programming of your PIA. When choosing a location to mount the components, care must be taken not to interfere with any of the vehicles existing systems. Good installation practices should be observed when mounting components to avoid any vibration, movement or rattling after installation.
2. If the vehicle has roof racks or skid ribs, it may be necessary to mount the antenna off-center. 3. If the vehicle roof does not provide sufficient metal surface area then the antenna can be mounted on the metal trunk lid at least 4" from the rear window. (autIDn: DO NOT INSTALL ANTENNA INSIDE VEHICLE PASSENGER COMPARTMENT. Mounting the antenna in the passenger compartment either on the front dash board or on the rear window deck area of the vehicle may interfere with reception and must be avoided.
2. For antenna mounting locations at the front or middle of the roof, the cable can be routed down along the door jam and into the car. In some cars, the cable may be brought into the vehicle through the grommet in the door jam which carries the power window and power lock wires. Ifthe cable does not fit easily through this grommet, do not try to force it through. Instead, route the cable under the weather seal near the lowest part of the trunk to reduce possible water leaks. 3.
Step 2 Connect the cable into the PIA. Plug the other end of the cable into the head unit (Cable sold separately). Read your cable installation manual for proper installation to your specific head unit. Step 3 Start your car and turn on your unit to confirm that the XM Direct system is properly connected. When you tune to XM channell, you should see uXM Preview" on your head unit LCD, and hear that channel through your car speakers.
StepS Return the car stereo head unit back to its original location in the dash board, be careful with cables that you just installed so that they do not unplug or get kinked by the head unit. Note: If you had removed screws to pull the car stereo head unit out please screw those back in. Step 6 If you had removed the dash board during installation please return it back to its original location.
XM Satellite Radio Operation Please refer to the "XM tuner control features" section of your cassette, CO or mobile video receiver manual for instructions on operating your XM satellite radio service. XM Radio lD 1. During XM Satellite Radio reception, press the Seek button to select "CHANNEL 0." 2. Press the "Seek - (down)" button. "RADIO 10" is indicated for 2 seconds and the XM Radio ID number is indicated for 10 seconds. To cancel the XM Radio ID display, press the Seek button to select a channel.
Troubleshooting No Sound • Adjust the volume control of the head unit. • Make sure that all of the cables between the PIA and the head unit and the tuner are securely plugged in. AdvisoryMessage When a problem occurs with the XM Direct system, an error message will be indicated on the display of the head unit. ANTENNA The antenna is not connected properly. • Check the connection of the antenna to the XM tuner. UPDATING Radio is being updated with latest encryption code.
Troubleshf)oting (Cont) OFF AIR The channel currently selected has stopped broadcasting. • Automatically switches to valid channel. No action is required. LOADING The receiver is reading the channel information. • Wait until the XM tuner completes receiving the information. NO INFO No information is available to display. • No action is required. "CH --" The channel to be tuned is void due to a channel lineup change. The tuner will automatically switch to a valid channel. • No action is required.
~AUDIO"'O~ ~ Ri.F:CTRON1CS CORP. 12MONTHLIMITEDWARRANTY I PROGRAMMABLEINTERFACEADAPTERCNP2000UCA I AUDIOVOX ELECTRONICS CORPORATION (the Company) warrants to the original retail purchaser of this product that should under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such defect(s} will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor.
WARRANTY (Cant) THE EXTENT OF THE COMPANY'S LIABILITY UNDER THIS WARRANTY IS LIMITED TOTHE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY'S LIABILITY EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT. This Warranty is in lieu of all other express warranties or liabilities. ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, SHALL BE LIMITED TO THE DURATION OF THIS WRITTEN WARRANTY.
PRODUCT REGISTRATION Thank you for purchasing an Audiovox product. We pride ourselves on the quality and reliability of all our electronic products but if you ever need service or have a question, our customer service staff stands ready to help. Contact us at www.audiovox.com PRODUCT PROTECTION: In case of an insurance loss such as fire, flood or theft, your registration will serve as proof of purchase.
1. 2. 3. 4. 5. Locate XM Direct 2 Mini-USB port on module. Attach XM Direct 2 USB programming cable. Locate USB 2.0 port on your computer Attach other end of XM Direct 2 programming cable. Program XM Direct 2 module per latest website instructions. www.audiovox.
CONTENTS INCLUDE: Interface Adapter XM Direct 2 Vehicle Tuner Magnetic Mount Antenna Programming Coble- CONNECTION CABLE REQUIRED Choose the proper XM Connection Cable for your car stereo. Advent Alpine Clarion Eclipse Jensen Kenwood Panasonic JVC Sony Speak with 0 Soles Representative for derolfs.
