Service manual

30
Seat Belt, Center and Rear
1. Remove screws from valance wood trim, pull out and disconnect plug in connector.
2. Remove valance.
3. Remove wall per procedures.
4. Remove seat belt plastic insert from wall.
5. Remove 2 nuts from seat belt retainer
* (Critical items ensure when reinstalling seat belt that these 2 nuts are
torqued to 6 to 8 foot lbs.).
6. Pull back seat belt boot located on floor which will expose seat belt anchor bolt,
remove
* (Critical items ensure when reinstalling seat belt anchor bolt that it is
torqued to 22 to 28 foot lbs.).
Seat Belt Driver
1. Remove valance wood trim.
2. Remove seatbelt.
Seat Belt Sofa Lap
1. Peel back seat belt boot cover exposing mounting bolt, remove bolt.
2. Pull seat belt through elastic retaining loop in sofa remove.
* (Critical item seat belt mounting bolt must be torqued when reinstalling 22
to 30 foot pounds)
Shade Cargo Door, Side And Rear
1. Locate shade retainer clips behind shade and using thumb press down on bottom
clip and pull out on shade until it releases from clip.
2. Grasp shade string at bottom where grommet enters into door shroud and pull out-
ward until string grommet releases from hole, repeat procedure for other string.
Shade, Vista Bay Windows
1. Remove 3 screws attaching shade to top of window.
2. Remove screw from shade string tensioners located at bottom of window.
Shroud, Rear Cargo Doors
1. Remove window shade; refer to shade removal procedure.
2. Remove door panel; refer to door panel removal procedure.
3. Remove screws.
4. Remove screws from factory window latch.
5. Grasp shroud and pull outward to remove.
Shroud, Side Cargo Doors
1. Remove window shade; refer to shade removal procedure.
2. Remove door panel; refer to door panel removal procedure.
3. Remove screws.
4. Remove screws from factory window latch.
5. Remove door lock knob by unscrewing and pulling up.
6. Grasp shroud and pull outward to remove.