Service manual

31
Sofa Motor
1. Remove sofa motor shroud.
2. Remove right side bolt from sofa frame attaching bracket to motor. (This releases
bracket).
3. Remove 5/16" nuts from end of sofa motor on both sides.
4. Unplug power wires from control module.
5. Grasp and pull drive cable loose from motor.
6. Remove sofa motor.
Sofa Motor Control Module
1. Unplug 2 connectors from module
2. Remove screws from base
TV
1. Grasp edges and pull forward.
2. Disconnect RCA cable from video in and audio in (color-coded).
3. Remove coax cable.
4. Remove external speaker connection.
5. Remove DC power input cable.
TV Console
1. Remove VCP (refer to VCP removal procedure).
2. Remove TV (refer to TV removal procedure).
3. Remove 2 screws in L bracket located inside frame attached to floor.
4. Grasp console and lift upward while guiding VCP and TV wires through opening in
rear of console.
Valance
1. Remove shades per procedure.
2. Remove screws that were exposed upon shade removal.
3. Remove valance wood trim.
4. Remove exposed pod screws.
5. Remove screws inside valance cutouts.
6. Untuck material from front and rear of valance to expose screws.
7. Remove screws from front and rear valances and lower valances.
VCP
1. Remove TV (refer to TV removal procedure).
2. Remove 2 screws attaching VCP bracket from underneath (Top of edge of console
where TV was removed from).
3. Grasp VCP by edge pull straight back until out of console.
4. Disconnect RCA jacks and power wire.