Service manual

40
Wall, Driver
1. Remove 6 exterior screws from upper wall wood trim, pull straight back and discon-
nect wires.
2. Remove sheer (3 screws at top) lower sheer down and rest on window ledge.
3. Remove screw from seat belt pod tab.
4. Remove 3 upper interior screws from top of Sport Top Wall through opening created
with removal of valance trim.
5. Remove 2 tack screws from bottom of Sport Top Wall.
Wall, Passenger
1. Remove 4 exterior screws from Upper wall wood trim, pull straight back and discon-
nect wires.
2. Remove shade (3 screws at top) lower shade down and rest on window ledge.
3. Remove screw from center seat belt pod tab.
4. Remove 2 upper interior screws from top of Sport Top Wall through opening created
with removal of valance.
5. Remove rear seat belt pod (1 hidden screw located 1" down from top under fabric at
center) remove 1 screw from pod tab remove pod.
6. Remove 2 tack screws from bottom of Sport Top Wall, located in top of window
frame.
7. Remove Sport Top Wall by sliding rearward until it comes out from under center
pod, now pull straight back to yourself.
Wall, Upper Sport Top, Driver Side
1. Remove applicable valance wood.
2. Remove storage box by removing external screws, grasp and pull up and out.
3. Remove 4 screws from bottom edge under valance.
4. Remove rear box per procedure.
5. Remove upper Wall wood trim.
6. Tilt bottom outward to access 5-L brackets, remove screws from brackets (located at
top of Sport Top Wall. These attach the Sport Top Wall to headliner).
Wall, Upper Sport Top, Passenger Side
1. Remove applicable valance wood.
2. Remove storage box by removing external screws, grasp and pull up and out.
3. Remove 4 screws from bottom edge under valance.
4. Remove rear box per procedure.
5. Remove Upper Wall wood trim.
6. Tilt bottom outward to access 5L brackets, remove rear box screws from brackets
(located at top of Sport Top Wall. These attach the Sport Top Wall to the headliner.)
Window Ring Removal Driver Side
1. Remove bottom windowsill.
2. Remove valance per procedures.
3. Repeat the above procedure for the 2nd vista bay window.
* Note
It is critical that the wall is loose at both window-mounting points.
4. At driver door peel back fabric on wall, this will expose screws. Remove screws.
5. Remove driver front factory seat belt shroud.
6. Remove driver center seat belt retainer if removal is for the rear window.
7. Pull bottom of wall away from window ring.