Service manual

46
Soffit, Driver Side
1. Remove shade (see procedure).
2. Remove the exposed screws.
3. Remove the Map lights cover and remove exposed screws. Lower light and discon-
nect.
4. Untuck the fabric at the front of the soffit to expose the hidden screw. Remove
screw.
5. Pull the top of the soffit to release the top from the J-channel.
6. Remove the seat belt retainer bolt and thread the seat belt through the seat belt
cutout.
7. Remove the exposed screws.
TV Console
1. Grasp edges of TV, pull out and disconnect.
2. Grasp edges of VCP, lift out and disconnect.
3. Remove screws connecting L-bracket to floor and remove TV console.
Wall, Driver Side
1. Remove the mid seat.
2. Remove the sofa.
3. Peel back wall fabric from driver doorpost and expose-hidden screws, remove all
screws.
4. Remove shrouds driver side front and rear, (Refer to shroud removal procedure).
5. Remove Driver side soffit. (See soffit procedure).
6. Grasp wall at gas fill mid lower wall and pull down as you are pulling the bottom of
wall outward slide toward front of van until released from behind speaker panel.
7. Remove wall out through rear cargo doors.
Wall, Passenger
1. Push the mid seat forward.
2. Lay the sofa in the flat position.
3. Peel back wall fabric from cargo doorpost and expose-hidden screws, remove all
screws.
4. Remove window shroud (Refer to shroud removal procedure).
5. Remove side soffit. (See soffit procedure).
6. Grasp wall at gas fill mid lower wall and pull down as you are pulling the bottom of
wall outward slide toward front of van until released from behind speaker panel.
7. Remove wall out through rear cargo doors.
Window, Vista Bay
* Note
This is a 2-person operation
1. Remove window shroud (per procedures).
2. Remove all screws around the perimeter of the metal window frame.
3. Exit vehicle and go to outside of window and grasp at the top and bottom, pull
outward and set down.