OWNERS MANUAL DVD Player D1210

I. System Operation

1. Press POWER to switch the unit on or off. The switch indica-

tor will light red and the unit will go to the mode last used and

stored in memory.

2. Press DVD/TV/AV to select your desired mode. When switch-

ing the mode, the DVD player can memorize the present play

- ing point.

3. Press VOLUME UP/DOWN to raise or lower the sound level

Also used to make picture adjustments in the picture select

mode.

4. Each time PICture is pressed, the on screen picture adjust-

ment display cycles through “adjustment bars for VOLUME,

CONTRAST, BRIGHTNESS, COLOR and TINT. Then

use VOLUME UP/DOWN to raise or lower the level. This dis-

play will automatically turn off if no adjustments are made within

about 6 seconds, or if any other button is pressed.

5. Press MUTE to cut off all sound; pressing this button again

restores sound to the previously set level. MUTE may also be

released by pressing the VOLUME UP/DOWN.

6. Press SRS 3D to activate surround sound with the indicator

on.

J. Watching TV

1. Plug the coaxial cable of an external flat antenna into the base

on the rear top of the unit. In addition to normal broadcast re-

ception of VHF and UHF channels, connect the attached co-

axial connector to the antenna terminal on the lower left side of

the unit, and connect the cable to the coaxial connector for

CH1~CH125 reception.

2. With power applied to the system and the TV mode selected,

press TV/CATV on the remote control to select the regular 69-

channel Broadcast TV and the 125-Channel Cable TV (Stan-

dard Cable, HRC Cable, and IRC Cable) with on-screen dis-

play.