Owner`s manual

TROUBLESHOOTING
-28-
Sound
There is no
sound.
● The volume is set to the lowest level.
● The sound is switched off.
● The disc is in fast forward/reverse
playback.
● The sound is output through the
connected earphone.
● Turn up the volume.
● Press MUTE to switch on the
sound.
● Press
●
PLAY to resume the normal
playback.
Pull out the earphone and the
sound will output through the built-
in speakers.
The remote
control does
not
function.
● There is no battery in the remote
control.
● The battery is out of charge.
● The remote control isn't pointed to the
remote sensor.
● The remote control is out of its
operating area.
● The unit is shut down.
● Install a CR2025 lithium battery in
the remote control.
● Replace the battery with a new one.
● Make sure that the remote control is
pointed to the remote control
sensor.
● Make sure the remote control is
within the operating area.
● Switch off the unit and disconnect it
from the AC outlet. Then power on
the unit again.
Unable to play
a disc
● This disc is placed in the disc tray in a
wrong way.
● The unit isn't compatible with the disc.
● The disc is dirty.
● Check that the disc is placed in the
disc tray with its label side
upwards.
● Insert a compatible disc.
See page 25
● Clean the disc.
No Power
Symptom
Cause(s)
Remedy
Picture
There is no
picture
displayed on the
connected TV.
● Connect the AV OUT jack of this
unit and the AV IN jack of a TV
securely with an AV cable.
● The TV is not connected to this unit
securely with the AV cable.
● The adapter is not connected to the unit
securely or is not connected to the power
supply.
● Connect the adapter to the DC input
jack securely and then plug the
adapter into an AC outlet (for AC/DC
adapter) or the vehicle DC accessory
socket of a car (for vehicle DC power
adapter).
● The unit is turned off.
● Make sure that the unit is turned on.
If your DVD player does not seem to be functioning properly, check the items below
before contacting Audiovox Technical Support.