Owner's Manual

3/9
5
Plug mirror power harness into the connector on the mirror.
7
Find 12V switched ignition and attach t-tap using pliers. Repeat for
ground supply. Ensure t-tap is snapped together.
8
Plug the mirror harness into t-tap’s as noted above. Ensure the
spade is properly seated into t-tap.
Black w/ white:
12V Switched Ignition
Black:
Ground
Black w/ orange:
12V Switched
Ignition
Cable
Ties
Foam Tape
6
Route the mirror power harness to a location where 12v igni-
tion and ground lines are present. Secure the harness along
the route with foam tape and wire ties.
* Ignition and ground tap point are typically found in the
A-pillar, Junction Block or Overhead compartment.