Quick Start Guide

ManualsBrandsAudiovox ManualsBlu-ray/DVD PlayerAudiovox GMNAV1

Navigation Interface Operation:

GM Vehicles:

To change the OEM radio to Navigation Mode:

• Press on an open area on the screen for 3 seconds.

• Press the Nav switch if installed

• Press the SWC Nav switch for 3 or more seconds if installed.

Exit Navigation by:

• Pressing again on an open area of the screen for 3 seconds.

• Press the Nav switch.

• Press the SWC Nav switch for 3 or more seconds if installed

Summary of content (5 pages)

PAGE 1
Navigation Interface Operation: GM Vehicles: To change the OEM radio to Navigation Mode: • • • Press on an open area on the screen for 3 seconds. Press the Nav switch if installed Press the SWC Nav switch for 3 or more seconds if installed. Exit Navigation by: • Pressing again on an open area of the screen for 3 seconds. • Press the Nav switch.
PAGE 2
NAVIGATION QUICK START GUIDE Follow these easy steps and you are on your way. NOTE: Full Navigation Manuals are available for download at www.adventproducts.com Step 1 - Start Up After the iGo primo software starts, you will see the reminder warning to use your iGo Primo software safely and lawfully.
PAGE 3
Step 3 - Select a Destination You have many ways to select a destination. Select by touching screen: • Tap to select your destination by entering an address or selecting a place of interest, a location on the map or one of your Favorite destinations. You can also look up your recent destinations from the Smart History, enter a coordinate or use the location saved in a photo. • Tap to display the route parameters and the route in its full length on the map.
PAGE 4
Step 5 - Arriving at Your Destination When you are near your destination, the destination is indicated by a checkered flag symbol . Destination Arrived Screen Refer to the complete navigation operation manual located online at www.adventproducts.com to become familiar with the many options available from your iGo Primo navigation software. Adjusting the Navigation Voice Volume While the Navigation is on and a route has been programmed, the Navigation will speak commands.
PAGE 5
Warnings and Precautions WARNING! Please read and follow the following safety precautions. Failure to follow the instructions below may increase your risk of collision and personal injury. The Attention - Please Drive Safely! Screen is displayed each time the iGo primo software is turned ON as a reminder to make use of the system’s navigational aids in a safe manner. The iGo primo software is not a substitute for your personal judgment.