Owner`s manual

9
HR7012 REAR SEAT VIDEO HEADREST SYSTEM Owner’s Manual
REMOTE CONTROL AND HEADPHONE BATTERY INSTALLATION
Installation of the Remote Control Battery
Figure 7
Figure 8 Figure 9
The remote control comes with a battery already installed with a Pull Tab to prevent battery
discharge. Remove the Pull Tab before attempting to use the remote. (Figure 7).
Note: The remote control will only operate this device. It is not a universal remote control and
will not control other equipment.
Remote control
Back View
CR2025
3V
Protective Pull Tab (Clear Plastic )
(1)
(2)
(1)
1. While holding the remote control, insert thumbnail into the battery door side notch (1) and
index ngernail into battery door upper notch (2) and slide battery holder open (Figure 8).
2. Install one CR2025 battery (1) (Figure 9).
Note: Make sure that the proper polarity (+ or -) is observed.
3. Slide the battery holder back into the remote control until it locks (Figure 10).