Owner`s manual

5
HR7012 REAR SEAT VIDEO HEADREST SYSTEM Owner’s Manual
Turn ON the Monitors (M1 and M2).
1. Press the Power ON/OFF button. The
power indicator will light up red.
2. Insert a DVD, CD, MP3 disc into the disc
slot located on top of the M1 monitor
(disc label toward user). Push down
gently on the disc until the player pulls
the disc in (Do Not force disc) or connect
a video source through the jacks on the
front panel.
3. Tilt the monitor to a comfortable
viewing position.
4. The supplied wireless IR headphones
have an ”A-B” switch used to select
the audio from either the “M1” or
“M2” monitor. When sitting in front
of the M1 screen, use the CH. A setting.
When sitting in front of the M2 screen,
use the CH. B setting. Set the headset
to the proper channel and press the
Power On/O switch. The power
indicator will light up red. Turn the
volume down to its lowest setting
before putting the headphones on.
QUICK START GUIDE
5. When the DVD menu appears, select
the menu item using the UP/DOWN
buttons and press Enter or Play button.
6. If audio playback through the
vehicle radio is preferred, use the FM
transmitter ON/OFF button on the
remote control. Set the vehicle radio to
the channel selected on the M1 monitor.
If interference with a local radio station
occurs, set the FM modulator to one
of the other 100 radio frequencies
using the Channel Select buttons on
the remote control or front panel.
Note: To operate the M1 screen, press
M1 on the remote control. To operate
the M2 screen, press M2.
7. To turn OFF either M1 or M2, press and
hold the Power ON/OFF button for 5
seconds or turn the vehicle OFF.