'9' In-Dash Single Disc DVD/CD Player Before operating the unit, please read these instructions carefully 128-5987
Operating Instructions Welcome Thank you for purchasing this DVD/CD player. Before operating the unit, please read this manual thoroughly and retain it for future reference. IMPORTANT NOTES To prevent an electrical system short which could cause serious damage to the unit, the vehicle, or cause personal injury, please follow the safety recommendations below: • Should there be requirement to replace a blown fuse, remember to first disconnect all power and switch off the unit before fuse replacement.
Operating Instructions • Depending on reception quality of the TV, noise interference may appear while a broadcast is being received with the DVD powered on. This is not a malfunction of the DVD or the TV. To watch a TV broadcast, turn off the DVD. • To prevent an operational malfunction, do not play discs other than DVD audio discs, DVD-ROMs, CD-ROMs, Photo CDs and DVDs with region numbers other than this player’s region number.
Operating Instructions INSTALLATION GUIDE Precautions: 1. This DVD/CD player should be install by qualified technician or service personnel. 2. The DVD/CD is designed to operate with a 12 Vdc, negative ground battery system. 3. Disconnect the ground wire from the battery terminal before connecting the unit to the electrical system. 4. The wiring from other units or accessories might display a similar color code to this product; however, they may not perform the same function.
Operating Instructions Back Panel The figure below shows the back panel design for the player. It also indicates the wire definition for interconnections.
Operating Instructions 2.1 Remote Control Reference Guide 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13 14. Power Button Setup Button Display Button Up Cursor Key Left Cursor Key Enter Key Previous/Reverse Skip Button Down Cursor Key Reverse Scan Button Play/Pause Button Subtitle On/Off Button Subtitle Selection Button Numeric Buttons Eject Button 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. 27.
Operating Instructions 2.2 Front Panel Control Reference Guide 1 2 QHFYR[ 3 4 DXWR PRELOH GYG FG SOD\HU '9$ ; SENSOR 20 19 AUDIO 0 18 FR PAUSE FF MENU 0 $ 17 16 15 14 ¡s PLAY TITLE 1. Power Indicator 2. Disc slot 3. Remote Sensor 4. Eject Button 5. Cursor Right Key 6. Cursor Up Key 7. Enter Key 8. Cursor Down Key 9. Cursor Left Key 10. Play Button 11. 12. 13. 14. 15. 16. 17. 18. 19. 20.
Operating Instructions 3. Basic Functions 3.1 DVD Playback (DVD) 1) Press the POWER( ) button on the remote control, or the DVD/CD player front panel POWER ( ) button to switch on unit power. 2) Insert a disc into the unit. 3) DVD playback commences: • The disc will start to play if the disc does not have any menu recorded on it. • If the disc has one or more titles recorded on it, a menu screen will appear on the TV monitor.
Operating Instructions 3.2.2 Playback Video CDs with Playback Control Without Using Menus (VCD) 1) Press the MENU/PBC button to set PCB off. 2) “PBC OFF” will be displayed on the TV screen. 3) Press the required track number button to select the preferred track, or press the PLAY/PAUSE ( ) button to commence playback. To return to menu playback: 1) Press the MENU/PBC button: “PBC ON” will be displayed on the TV screen. 2) The menu (if available) will be displayed on the TV monitor. 3.
Operating Instructions 3.4 Next track or previous track (CD/VCD/DVD) Press during playback. Audio CD and Video CD: The player will skip forward to the next track each time the button is pressed. “SKIP FW” will be displayed on the TV screen. DVD: The player will skip forward to the next title/chapter each time the button is pressed. “SKIP FW” will be displayed on the TV screen. Press during playback.
Operating Instructions 3.8 Search Function (CD/VCD/DVD) The Search function enables you to pinpoint a specific location by entering the time/track/chapter or title. Audio CD: When the SEARCH button is pressed the following will be displayed: TRACK xx TIME xx:xx CD Use the numeric keys to enter the desired track or disc time; pressing the ENTER button will cause the player to start playing at the selected track or time.
Operating Instructions DVD: When the SEARCH button is pressed the following will be displayed: TITLE xx CHAPTER xxx TIME xx:xx:xx No display Use the numeric keys to enter the desired title or chapter, or chapter time; pressing the ENTER button will cause the player to start playing at the selected title, chapter or chapter time. If you are not in search mode, you may use the numeric keys to enter the desired chapter; the player will commence at the selected chapter. 3.
Operating Instructions For DVD: When the REPEAT button is pressed: RPT CHAPT RPT CHAPT RPT TITLE REPEAT OFF = = = RPT TITLE REPEAT OFF The current chapter will be repeated The current title will be repeated Repeat mode will be switched off 3.9.2 Camera Angle (DVD) Some DVD discs may contain scenes which have more than one viewing angle.
Operating Instructions 3.9.4 Subtitle (DVD) During DVD playback, you may change the subtitle language from the one selected at the initial setting to a different language, if available. 1) When the SUBTITLE ON/OFF button is pressed: SUBTITLE ON SUBTITLE OFF 2) During DVD playback with SUBTITLE ON, press the SUBTITLE button . “SUBTITLE x/y” will appear, where x represents the current subtitle and y represents the total available subtitle. Press the SUBTITLE button until the preferred subtitle is selected.
Operating Instructions 3.9.7 Display Function (CD/VCD/DVD) The display function enables you to view the status, current title number, track number and the total playing time of the disc on the TV screen.
Operating Instructions DVD: When the display key is pressed, the following OSD will be shown: TITLE 1/8 CHAPTER 1/20 CTIME 02:14:21 ANGLE 1/3 SUBTITLE 2/3 AUDIO 1/3 TITLE 1/8 CHAPTER 1/20 CRIME 02:14:21 ANGLE 1/3 SUBTITLE 2/3 AUDIO 1/3 TITLE 1/8 CHAPTER 1/20 TTIME 020:14:21 ANGLE 1/3 SUBTITLE 2/3 AUDIO 1/3 TITLE 1/8 CHAPTER 1/20 TRTIME 21:14:21 ANGLE 1/3 SUBTITLE 2/3 AUDIO 1/3 No display CTIME CRTIME TTIME TRTIME = Chapter time = Chapter remaining time = Title time = Title remaining time 3.9.
Operating Instructions (1) Disc Language a) During STOP, press the SETUP button; the setup menu will appear. buttons or numeric key to select the DISC LANGUAGE item; then b) Use the / press the ENTER button. The disc language menu will appear as follows: DISC LANGUAGE (1) AUDIO (2) SUBTITLE (3) MENU c) Use the buttons or numeric key to select AUDIO/SUBTITLE/MENU, then press / the ENTER button.
Operating Instructions (2) Password NOTE: The factory default password is 1234 a) During STOP, press the SETUP button, the setup menu will appear. buttons or numeric key to select the PASSWORD item, then press the b) Use the / ENTER button. The change password menu will appear. CHANGE PASSWORD PARENTAL PASSWORD c) Use the numeric keys to enter the password; then press ENTER. d) If the correct password is entered, the user can now enter the new password.
Operating Instructions (3) Parental Control a) During STOP, press the SETUP button, the setup menu will appear. buttons or numeric key to select the PARENTAL item; then press ENTER. b) Use the / The DVD/CD player will request a parental password. PARENTAL PASSWORD PASSWORD c) Use the numeric keys to enter the password; then press ENTER.
Operating Instructions (5) Digital Out a) During STOP, press SETUP button, the setup menu will appear. buttons or numeric key to select the DIGITAL OUT item, then press b) Use the / ENTER. The preferred digital audio output will be shown as follows: DIGITAL AUDIO OUT (1) LPCM (2) DOLBY DIGITAL (3) MPEG buttons or numeric key to select the preferred digital audio output, then c) Use the / press ENTER. d) The SETUP menu will be shown.
Operating Instructions 4. Product Specification GENERAL Power Supply Current Consumption Operating Positions Dimension (WxHxD) Inches (Millimeters) Weight : 12VDC Typical : Less than 3.0 A : Horizontal mount only : 7 (178) x 2 (50) x 7.4 (190) : 2.0 kg AUDIO Output Frequency Response Distortion Dynamic Range S/N Ratio Cross Talk Optical Output : 700mV rms, 600Ω : 20 Hz to 20 kHz (CD audio / 44.1kHz sampling) : 0.02% (at 1 kHz) : Above 85dB : ≥ 90dB : -75dB : Connection to DSP unit for 5.
Operating Instructions 5. Region Management Information This DVD/CD player is designed and manufactured to respond to the Region Management Information that is recorded on a DVD disc. If the Region number described on the DVD disc does not correspond to the Region number of this player, this player will not be able to play the DVD disc. This DVD/CD player is set to work only in a particular world region as labeled on the player. Region Number 1 2 3 4 5 6 Country Within the Region Canada, U.S, U.