www.audiovoxproducts.
IPD-SB OWNERS MANUAL
INTRODUCTION Congratulations on your purchase of the IPD-SB Sound Bar. Please read the instruction manual for this product before using. The documentation provided will allow you to fully enjoy all the features this unit has to offer. Please save this manual for future reference. WARNING! Never install this unit where operation and viewing could interfere with safe driving conditions. WARNING! Never disassemble the unit.
Package Includes: Sound Bar IPD-SB Mini USB Charging Cable Owner’s Manual Sound Bar Bracket 3.5 mm AUX-IN Cable CONTROLS AND INDICATORS IPD-SB FRONT VIEW 1. 2. 1 2 ellow LED Y When the LED is ON the battery is being charged. When the LED is OFF the battery is fully charged. Red LED When the LED is ON the battery charge is low.
IPD-SB REAR VIEW 1 1. 2. 3. 4. 5. 6. 2 3 4 5 6 evice Holder D When the stand is in the open position, most tablet devices, MP3 players or cell phones can placed and held within the stand notches. STAND Opens to hold most tablet devices or cell phones placed within the stand notches. -VOL+ Adjustment Rotate to increase or decrease the volume. AUX IN Jack Accepts a 3.5mm jack which is used to accept audio inputs from an external device.
OPERATING INSTRUCTIONS Power On/Off Use the rear panel slide switch to turn the Sound Bar ON and OFF. The LEDs on the front panel light or blink depending on the Sound Bar status. Battery Charging To charge the Sound Bar battery, connect the mini USB connector to the rear panel DC 5 V connector. Connect the USB connector to a USB port on a computer. Allow the unit to charge fully before using it. Volume Adjustment Rotate the rear panel volume control to increase or decrease the volume.
Sound Bar Device Stand (may not work with all devices) 1. Place the Sound Bar on a flat surface and open the rear panel stand as shown. 2. lace the device in the Sound Bar holding slot P which provide the best fit for your device.` 3. T he viewing angle of the device in the stand can be adjusted by moving the two stands as shown.
Sound Bar Vehicle Installation The Sound Bar can be attached to an optional Audiovox iPad protective case (IPD-1, IPD-2C, IPD-2HP, IPD-2FM, sold separately) for in-vehicle installations. Refer to the figure below. The included Sound Bar Bracket and optional Audiovox vehicle kit are required for vehicle installations. The headrest post mount and protective case are not included in this package. For further information, refer to the Audiovox website at www.audiovoxproducts.com.
Sound Bar Bracket Installation The Sound Bar can be attached to a protective case using the Sound Bar bracket for in vehicle installations. Refer to the figure below. NOTE: Before installing the Sound Bar set the Sound Bar volume to the maximum setting. The Sound Bar volume will be controlled through the volume control of the iPad, if the headphone audio out of the iPad is connected to the audio-in of the Sound Bar. Protective Case Mounting Bar Headrest Mount 1. 2. 3.
4. hile holding the red switch on the protective case mounting arm in the unlock position, W insert the mounting arm with the Sound Bar Bracket into the Headrest Mount and release the red switch to lock the unit into the headrest mount. Inserting the Sound Bar into the Sound Bar Bracket 1. lign the two tabs on the Sound Bar Bracket with the two mounting holes on the rear panel of A the Sound Bar. Refer to the figure below.
2. Push the Sound Bar down and back into the Sound Bar Bracket. 3. The Sound Bar will snap into place on the Sound Bar Bracket.
Removing the Sound Bar from the Sound Bar Bracket 1. To remove the Sound Bar from the Sound Bar Bracket, press downward on the tab located on the bottom of the Sound Bar Bracket. Refer to the figure below. 2. The Sound Bar will snap free of the Sound Bar Bracket.
Product Specifications Power Input 5V DC 500mA Battery Life About 8-10 hrs (Depending on output volume level) Loudspeaker 2W X 2 Output 85 dB @ 0.5m Dimensions 1.61 inch (H) X 9.44 inch (W) X 1.
12 MONTH LIMITED WARRANTY Applies to Audiovox Mobile Video Products AUDIOVOX ELECTRONICS CORP. (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such defect(s) will be repaired or replaced with reconditioned product (at the Company’s option) without charge for parts and repair labor.
