LCM1210FD Owner’s/Installation Manual LCM1210 Flip-Down In Vehicle Entertainment System Audiovox Specialized Applications, LLC 23319 Cooper Dr.
Rear Panel Features: 1 3 2 4 5 6 1) 2) 3) 4) Left RCA Out: Hook-up for the left audio out (white male RCA jack) Right RCA Out: Hook-up for the right audio out (red male RCA jack) Power Harness Connection: This plug connects to the power harness mating plug Optional Headphone Connections: Green is right positive, Gray is left positive and Black is the ground 5) Antenna Connections: This connects to the antenna if applicable. 6) DIN Connectors: The source component harness (P/N 8010730) connects here.
General Installation Approach: 1) Before beginning installation, please refer to warning on page 10. 2) Decide upon system configuration and options that will be installed (ie: what components, VCP, remote headphones, 2nd VCP, etc). 3) Review all manuals to become familiar with electrical requirements and hook ups. 4) Decide upon mounting locations of all components and method of mounting.
Vehicle Preparation: 1) Locate vehicle power source. Generally this is best found near the vehicle’s fuse block, which is usually (though not always) under the steering wheel area. Locate an accessory hot circuit to tap into video system power. Accessory hot means a circuit that is +12VDC when the ignition key is in either the “ACC’Y” or “Run” positions, and 0 volts DC when the ignition key is removed from the vehicle.
Wiring Diagram Hook Up Procedure: 1) Connect the power harness to the mating connector on the video pod. 2) Connect the power harness to vehicle’s electrical system by tapping into an accessory hot line. 3) Verify all functions of the system before final mounting of the finished assembly. Left Out (White) Right Out (Red) FM Modulator and wireless headphones could be connected with two dual RCA patch cords, connected to L and R output jacks shown above.
Wiring procedure and Hook Up Diagram cont.: Mini-Din Connection Detail FM Modulator/Wireless Headphone Connections FM Modulator white RCA jacks to Red RCA (Right Audio Out) and Red or Yellow RCA from Modulator to Red RCA (Left Audio Out).
Remote Control Functionality: TELEVISION CONTROLS: 1) TV Power: Turns unit on/off 2) TV/Video: Toggles between 3 available sources; Tuner/VCP/DVD (VCP2) 3) Mute: Mutes headphone audio 4) 0-9: Numbers for channel selection 5) ∆ CH: Channel Up 6) ∇ CH: Channel Down 7) ∆ Vol: Volume Up 8) ∇ Vol: Volume Down 9) Skip/Search: Toggles on/off.
Roof Structure Optional Spacers C4 C5 Screw Boss Note, If longer screws are substituted, care should be taken to prevent piercing the roof, and be sure that pan head screws and washers are used to prevent screws from pulling though the screw boss. Nylon spacers have been supplied in accessory kit to place under mounting screws and/or under screw bosses. They can be cut to size as needed.
Troubleshooting: Symptom: Picture scrolls or is fuzzy Cause: Antenna type or location Poor Reception Vehicle is moving Not receiving certain channels Connections Unit will not respond to remote control Sensor is blocked No power to unit Batteries in remote control are weak Power connection Fuse blown at fuse panel For Installation Help, Call: Audiovox Specialized Applications, LLC 800-688-3135 M-F, 8:00AM –5:00PM CST 9 Possible Solution: Change antenna or try antenna in a different location Vehi
Specifications: Video System: A/V Switching: Power: Aux Audio Outputs: Current Consumption (stand-by mode): Current Consumption (on, but no VCP): Current Consumption (with one VCP on): Audio Noise Floor (30KHz BW): THD+N @ -10dBV, 1KHz (30KHz BW): Crosstalk @ 1KHz: Maximum Input Level, Audio L and R: Frequency Response, 20Hz – 20KHz: Frequency Response, 40Hz – 16KHz: Channel Balance: Volume Control: Unit Weight: NSTC Analog Composite Video (1V P-P, 75Ω) 3 channels 10-16 VDC, Negative Ground Left and Right
Accessory List Description AVT-988 9” Color Television with Remote (12V) AVT-597 5” Color Television with Remote (12V) AVT-1498 13” Color Television with Remote (12V) AVP-7000 Video Cassette Player (12V) AVP-7285 Video Cassette Player (12V) Wireless Headphone Kit: Includes 2 sets Wireless Headphones and Transmitter BPA-501-12 4 Amp Adapter for use with AVT-988 9” and AVT-1498 13” Televisions AC2A- 2 Amp Adapter for use with AVT-597 5” TV and AVP-7000 Video Cassette Player Unified Remote Control VAC-21- 12 V
