SATELLITE DIGITAL AUDIO RECEIVER SYSTEM MODELS SRSIR-001, SRSIR-001FM and MODEL SRSIR-001FMR ® INSTALLATION MANUAL For Customer Service Visit Our Website At WWW.audiovox.
INTRODUCTION The Audiovox Electronics SIRIUS® Satellite Digital Audio Control And Receiver System (Model SRSIR-001 and SRSIR-001FM) was developed to allow the user to listen to a huge selection of programming supplied by a subscription to SIRIUS® Radio. (SIRIUS® compatible antenna required).
INSTALLATION and WIRING PRECAUTIONS 1. To prevent a short-circuit, Be sure to turn off the ignition and remove the negative(-) battery cable, prior to installation. Connect power wires last. NOTE: If the SRSIR-001 / SRSIR-001FM/ SRSIR-001FMR System is to be installed in a car that is equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost.
PACKING LIST SRSIR-001 / SRSIR-001FM / SRSIR-001FMR (NOTE: Components are not drawn to scale.) MAIN SYSTEM COMPONENTS RADIO RECEIVER UNIT (RRU) SRSIR-001FM AND SRSIR-001FMR RADIO RECEIVER UNIT (RRU) SRSIR-001 P/N 144D2346 SATELLITE SYSTEM CONTROL UNIT (SCU) P/N 144D2345 P/N 144D2347 AUDIO OX TER. SAT. AUDIO OX -or- L TO SCU 2 3 4 5 6 7 8 9 0 AUDIO OX AUDIO OUT R 1 TER. POWER SAT. AUDIO OUT R L FM OUT TO SCU POWER 1 pc. 1 pc. SFT 1 pc.
TER. SAT. R L AUDIO OUT FM OUT TO SCU AUDIO OX POWER NOTE: “C” Before routing the Din Cable to connect the SCU to the RRU, observe the gender (Male / Female connector) of the cable to avoid any unnecessary re-work. The Female connector is matched to the SCU and the Male connector is matched to the RRU. NOTE: “B” RCA to RCA Cable (supplied with system) used to connect the RRU Audio Ouput to the Radio Reciever Audio Input.
TER. SAT.
TYPICAL FM MODULATED INSTALLATION for SRSIR-001FM SYSTEM COMPONENT LAYOUT 7
SYSTEM INSTALLATION RADIO RECEIVER UNIT (RRU) PROCEDURE for HORIZONTAL INSTALLATION of the RRU 1. Attach the mounting brackets to each side of the RRU, using the 4 Phillips Round Head Screws (4mm x 8mm). Bracket Phillips Head Screws (4mm x 8mm) used in 4 places 2. Determine the mounting location and drill 4x 1/8” (4mm) mounting holes. WARNING Never mount the unit near the fuel tank.
PROCEDURE for VERTICAL INSTALLATION of the RRU 1. Attach a mounting bracket to each side of the RRU, using the 4 Phillips Round Head Screws (4mm x 8mm). RRU Phillips Head Screws (4mm x 8mm) used in 4 places Bracket 2. Determine the mounting location and drill 4 x 1/8” (4mm) mounting holes. WARNING Never mount the unit near the fuel tank. 4x 1/8” (4mm) mounting holes Carpet NOTE: If mounting surface is carpeted, use caution when drilling holes to prevent drill bit from catching on carpet.
PROCEDURE for the MOUNTING of the RRU UNDER THE REAR DECK 1. Attach the mounting brackets to each side of the RRU, using the 4 Phillips Round Head Screws (4mm x 8mm). Bracket Phillips Head Screws used in 4 places (4mm x 8mm) 2. Determine the mounting location and drill four 4mm mounting holes. Underside of Rear Deck 4x 1/8” (4mm) mounting holes (4 places) 3. Mount the unit in place, using 4 Self-tapping Screws (5mm x 15mm), w/Flat Washers and Lock Washers.
INSTALLING THE SATELLITE SYSTEM CONTROL UNIT (SCU) PROCEDURE for a TYPICAL INSTALLATION of the SCU USING HOOK & LOOP ADHESIVE TAPE (SUPPLIED) 1. Determine where the SCU is to be located (flat surface) NOTE: The chosen position must allow a clear view of the display and easy access to the controls for both the Driver and Passenger of the vehicle. 2. Using an Alcohol Swab, clean and dry the entire surface area where the SCU is to be mounted and the back surface of the SCU. 3.
PROCEDURE FOR A TYPICAL BRACKET INSTALLATION OF THE SCU (Bracket not supplied) Audiovox suggests this type of installation over the Hook & Loop type of installation though the Hook & Loop installation (if done correctly) is a secure and sufficient mounting option. Installation of the SCU using a bracket results in a professional, factory-installed look, without visibly damaging the interior of the vehicle. There are several types of brackets available to accomplish this type of installation.