Installation manual

ManualsBrandsAudiovox ManualsComputer equipmentLCM5869NP

PROCEDURE FOR A TYPICAL BRACKET INSTALLATION OF THE SCU

(Bracket not supplied)

128-6375A

Audiovox suggests this type of installation over the Hook & Loop type of installation though the Hook &

Loop installation (if done correctly) is a secure and sufficient mounting option. Installation of the SCU

using a bracket results in a professional, factory-installed look, without visibly damaging the interior of

the vehicle. There are several types of brackets available to accomplish this type of installation.

The installation procedure that follows, illustrates the use of a Pro.Fit

mounting bracket. Audiovox

has found that the Pro.Fit

VSM

line of mounting brackets are easy to install and compliments the

installation of the SCU. Pro.Fit

VSM

mounting bracket reduce the installation liability while maintain-

ing the resale value of a car because of the professional fit, professional look and safe design.

Currently Pro.Fit

VSM

offers hundreds of brackets, covering most popular cars, vans, and trucks.

Step-by-step instructions and technical support are available for every mount and application.

After the proper mounting bracket has been selected and installed using the Original Manufacturers

installation instructions, proceed with the following steps:

1. Connect the SCU Cable to the 6 - pin Din Cable from the RRU

2. Using the Phillips Head Screws and the External Tooth Lock Washers (supplied),

Mount the SCU to the bracket as shown in the Figure below.

NOTE: Use caution not to over tighten the screws into the back of the SCU as this may

cause damage to the unit.

Upon completion of the SCU installation and before the SIRIUS

radio is activated a test of the system

should be performed. To verify that the SRSIR-001/ SRSIR-001FM/ SRSIR-001FMR System and the

SIRIUS

Antenna have been installed correctly and are functioning, select and listen to CH 184. (SIRIUS

preview channel). If there is no power to the SCU check that all connections have been made and that

fuses are good. If there is no signal present, make sure that the SIRIUS

Antenna is unobstructed

(move vehicle) and for SRSIR-001FM check the antenna cable connection to the FM Antenna Switch-

ing Box For a detailed trouble-shooting guide, refer to the Owner’s Manual.

Do not install the unit in the following locations:

In Locations exposed to direct sunlight. Where hot air is discharged from the car heater. In

areas subject to extreme temperatures.

NOTE:

(Example installation position)

SFT

AUDIO OX

Phillips Round Head Screw (4mm x 8mm)

External Tooth Washer

(4mm int.)

Bracket

(Not Supplied)

Bracket Shown is a PRO.FIT for ordering information

visit www.pro-fit-intl.com

SCU