Rearview Mirror with 4.5" Color LCD with Navigation and 2 Camera inputs/Compass and Outside Temperature Model: LCMR6CT Owner’s Manual Features: Rearview Mirror with 4.
This product must be installed and used only in accordance with these instructions. Any alteration of this product that enables it to be used in ways other than those stated in this manual could distract the driver and result in an accident or injury. AUDIOVOX ELECTRONICS CORP. DISCLAIMS ANY LIABILITY THAT MAY RESULT FROM A FAILURE TO INSTALL AND OPERATE AS INDICATED IN THESE MANUALS. Warning: Backing up vehicle Do not back up vehicle while watching the mirror/monitor screen.
TABLE OF CONTENTS Cautions! -------------------------------------------------------1 Functions -------------------------------------------------------3 Operation -------------------------------------------------------4 Maintenance ----------------------------------------------------6 Congratulations on your purchase of this Rearview Mirror / Monitor with Outside Temperature and Compass display.
Figure 1 I. Functions Figure1 shows the function controls of the rear view mirror. A: 4.5" LCD Panel B: Rearview Mirror Glass C: “+”Button (optional Navigation System required) Incrementally increase volume level of the navigation voice command when pressed. Note: Will only operate when the Navigation System remote control is removed from the cradle.
G: H: I: J: K: Internal Speaker (optional Navigation System required) LCD Brightness Control Internal Infra-RED Receiver for use with Navigation System Remote Control. Power LED (Red when Power is on) Display Timer Slide Control Switch: (optional Navigation System required) Refer to # 3 below for detailed operation notes. L: “ T/C ” Button The temperature/compass button switches between Fahrenheit and Celsius settings and also turns the display on or off.
vehicle. For the convenience of those operators, a ‘Display Timer Slide Control Switch’ has been added to the mirror. A. When the Slide Control Switch is moved to the far right end position, the Navigation image will remain on at all times. B. When the Slide Control Switch is moved to the far left end position, the Navigation image will remain off at all times. C. Positioning the Slide Control Switch anywhere in the center area will automatically enable an internal timer.
6. Disabling the internal speaker Remove the L-Cover at the left end of the mirror using a Mini screwdriver (see Figure2), to gain access to the small switch inside. To disable the internal speaker, set the switch to the off position (See Figure3). Set the switch to the ON position to enable the internal speaker (see Figure3). Figure3 Figure2 7. How to Calibrate the Compass Direction A. Ensure the Compass Sensor has been securely mounted. B. Press the Calibration Switch to the “IN” position. C.
III. Maintenance Though your Rearview mirror requires little care, you can still maintain its condition and performance by following the procedures below. Keep your system away from excessive moisture, extreme heat or cold, and magnetic fields. Keep liquids away from the display and mirror. To avoid damage, do not place external devices or other objects on the top of the mirror. Occasionally wipe the rearview camera lens with a soft, damp cloth.
© 2005 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y.