Owner`s manual

LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated
functions on the display (8).
RESET FUNCTION
RESET button (25) must be activated
with either a ballpoint pen or thin metal
object. The RESET button is to be
activated for the following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
RADIO OPERATION
• SWITCHING TO RADIO MODE
Press MOD button (6) shortly to select
radio mode, the radio mode appears
in the display together with the
memory band and frequency.
• SELECTING THE FREQUENCY BAND
At radio mode, press BAND / LOUD
button (13) shortly to select the desired
band.
The reception band will change in the
following order:
• SELECTING STATION
Press
button (17) or button (16)
shortly to activate automatic seek
function. Press for several seconds
until “MANUAL” appears on the
display, the manual tuning mode is
selected. If both buttons have not
pressed for several seconds, they will
return to seek tuning mode and
“AUTO” appears on the display.
• AUTOMATIC MEMORY STORING &
PROGRAM SCANNING
- Automatic memory storing
Press AMS button (18) for several
seconds, the radio searches from the
current frequency and checks the
signal strength until one cycle search
is finished. And then 6 strongest
stations are stored into the
corresponding preset number button.
- Program scanning
Press the AMS button (18) briefly to
scan the station preset memories. The
radio will play each preset location for
several seconds, then move on to the
next memory location. To stop on a
given station, press the AMS button
again.
• STATION STORING
Press any one of the preset buttons
(14) (1 to 6) to select a station, which
had been stored in the memory. Press
this button for several seconds (until
2ND beeps), current station is stored
into the number button.
• MONO/STEREO
Press MONO button (1) to select mono
or stereo mode. You can sometimes
improve reception of distant stations
by selection mono operation.
• SCAN
Press SHIFT/SCAN button (2) to set
function to scan mode, which scanning
to higher frequency station with
receivable signal and keep on each
station for several seconds.
7
OPERATION
FM1 FM2 FM3 AM1/MW1 AM2/MW2