Installation guide

10
Installation
1. Verify compatibility, certain radios require
antenna adapter(s), not included in the kit.
5. Test for 12V costant, 12V switched, and ground sources.
Splice into with leads from power cable.
6. Route kit to glovebox or other accessible location.
7. Connect battery & test*
8. Complete install by re-installing radio
9. Save frequency to a preferred preset on the radio if
desired.
*Warning: Do NOT connect any mini-din and iPod cable used on other Audiovox
products to the mini-din port. Failure to follow this will cause permanent damage
to the unit/iPod!
2. Disconnect battery
3. Remove radio from car
4. Install Universal RDS USB cable. Plug the
factory radio antenna to the receptacle on
the module.
OMA-UNI-200-USB-012012_rev012312.indd 10 1/24/2012 10:06:05 AM