Installation manual

Step 1:
Remove the head unit from your dashboard.
Important: Depending on how your head unit was installed you may have to remove
part or all
of your dash board before the head unit can be pulled out. You may also
have
to remove screws to complete this step.
Note: Before proceeding, make sure that the PIA Adapter has been pro-
grammed. Refer
to the PIA Installation Manual. Professional installation is
recommended.
.6J-~-_ Left/Right
AudioCable
Connector
To Head Unit Note: Make sure all cables
Figure
1. PIA Cable Interface aresecurely connected.
Step
2:
Connect the 34-pin cable connector to the Programmable Interface Adapter (PIA) mating
connector
as shown in Figure 1. Slide the rubber strain relief onto the PIA case. Attach
the
Car Dock USB connector into the USB receptacle on the PIA. Make sure the connec-
tors ::i_::::::~dand -g-Slide the top cover onto t::e:~:tom housing. (Ref~~
Car Dock -- ~~
Pass-Through
Connector