Installation manual
Step
3:
Connect the end
of
the cable with the right angle
DIN
connector and audio cables
to
the back
of
the head unit
as
shown in Figure
2.
The shorter end
of
the cable coming
from the
PIA
is
a pass-through cable that
can
be
used
to
connect other products
to
your
head unit,
i.e.,
CD
changer.
Connector
/
LeftlRightAudio
Cables(Model Specific)
Figure 2. Typical
Head
Unit, Rear View
Note:
The
location
of
the connections on the head unit may vary depending on the
model.
Step
4:
Start your car and turn on your head
unit
to
confirm that the
XM
Direct system
is
properly connected.
Please
refer
to
your stereo owners manual on
how
to
a,ccess
XM
mode. When you tune to
XM
channell,
you should
see
"XM
Preview" on your head unit
LCD,
and hear that channel through your car speakers. If not, check
to
make sure all
connections are correct or refer
to
the troubleshooting section
of
this installation guide.
StepS:
Mount and secure the interface cable in a suitable location that will
not
interfere with
the radio and will
not
vibrate or rattle after installation.