Owner's Manual

MM92HR HEADREST INSTALLATION

Installing the headrest monitor(s) is straightforward and requires minimum effort. If you are unsure of the installation process after

reading these instructions, you may want to have this product installed by a professional. To install the headrest monitor, proceed as

follows:

1) Release the existing headrest and pull it straight up until it clears the back of the seat.

2) Note the distance between the steel tubes of the headrest just removed and adjust the

monitor headrest tubes together or apart as shown until they match this dimension.

Note: If internal seatback sleeve diameter is too big, insert the 12mm or 14mm sleeves into the

existing sleeves before installing the monitor headrest assembly.

3) Guide the monitor headrest cable into and through the seat sleeves tubes while inserting the monitor

headrest tubes into the seat sleeves. At the back of the seat, under the seat fabric, grasp the

headrest monitor cable and pull it down, avoiding any twisting or kinks. It may be necessary to cut

fasteners at the bottom of the seat to access the cables.

4) Mate the headrest monitor cable with the monitor cable assembly (AV input and power) as shown below.

5) Route the monitor cable assemblies to the video source (DVD, Game etc.).

6) It is recommended that a video amplifier (Audiovox VA100) be wired in line between the DVD player or game and headrest AV

inputs. This will prevent signal degradation of the video signal.

7) Connect the black wires to a good vehicle ground.

Connect the red wires to an ACC (switched 12VDC) source. Make sure that all power wires are fused.

Adjust tubes together or apart

DVD

ACC

Video1(yellow)

Audio1 R(red)

Audio1 L(white)

DC12V

GND