ADV10 10.
Important Notice Installation of overhead products requires careful planning and preparation. Be extremely careful when working on a vehicle with side curtain air bags. Do not route wires near any portion of the side curtain air bag assemblies. This includes any anchor points in A, B, C or D pillars of the vehicle. Routing wires in these areas or running wires by the side curtain air bags can prevent the side curtain air bag from fully deploying which can result in personal injury to vehicle occupants.
FEATURES Congratulations Congratulations on your purchase of the ADVENT ADV10 DVD Player with drop-down video / monitor. The ADV10 has been designed to give you and your family many years of video entertainment in the mobile environment. Please read the directions that follow to familiarize yourself with the product to ensure that you obtain the best results from your equipment. • 10.
CONTROLS AND INDICATORS DIAGRAM (FRONT VIEW) 1 4. STOP (n) Control - Press STOP once : Stops playback, Pressing the PLAY button again will resume normal playback from where movie was stopped. - Press STOP twice and then press PLAY to start playback from the beginning of the DVD. 2 3 4 5 6 7 5. EJECT () Control This control is used for ejecting disc from the disc compartment. 8 6. Three Position Dome Light Switch ON - Turns on the dome lights. OFF - The dome lights will not turn on in this position.
CONTROL FUNCTION DESCRIPTION (SIDE VIEW) 1 1. DVD Disc insertion Slot For loading and removing discs. CONTROL FUNCTION DESCRIPTION (BACK VIEW) 1 23 1. Auxiliary Video Input 2. Auxiliary Audio Left Input 3.
REMOTE CONTROL OPERATION MAIN FUNCTION OPERATION POWER 1 2 3 4 M2 TV DVD 30 SOURCE DVD SOURCE 5 6 CR2025 EJECT M1 MUTE VOLUME 27 PIX SYSTEM MENU DISC MENU 7 8 ZOOM REPEAT Initial Use When purchased the remote control has a battery installed with a Pull Tab to prevent battery discharge. Remove the Pull Tab before attempting to use the remote. DISPLAY SETUP SUBTITLE 10 AUDIO Battery Replacement 1. Remove the battery holder. 2.
* Function control is available on the unit and the Remote Control. ** Function not available in this model. 1. POWER* Press this button to turn the unit ON and OFF. 2. MONITOR SELECT M1 Button – Set the remote control code to allow control of the unit in M1 mode. M2 Button** – Set the remote control code to allow control of the unit in M2 mode. 3. SOURCE* Each time the button is pressed, the unit will cycle through modes DVD, AV1/AUX 4.
9. ENTER Used to implement a selected setting or menu option. 10. DISPLAY Press to display the current disc information while the disc is playing. Press the cursor (pq) buttons to select the Title or Chapter. For Title/Chapter selection use the numeric buttons to enter the desired Title /Chapter selection. 11. SCAN BACKWARD (7) Press to search in a backward direction. Press repeatedly to change the search speed from 2, 4, 8, 16 times and normal speed. 12.
19. STOP (<)* Press to stop playback.(Playback will resume from the point it is stopped). Press twice at once to stop playback fully. (Playback will resume from the beginning of the disc). 20. SCAN FORWARD (8) Press to search in a forward direction. Press repeatedly to change the search speed from 2, 4, 8, 16 times and normal speed. 21. AUDIO Press to display and select audio language in DVD mode. Each time you press the button, the language changes. Note: The available languages vary from disc to disc. 22.
26. ZOOM Press this button to enlarge the picture when playing a DVD disc. Press ZOOM button DVD player perform Once Q1- Enlarge the picture 2 times of the original size Second Q2- Enlarge the picture 3 times of the original size Third Q3- Enlarge the picture 4 times of the original size Forth Q off- Picture is returned to original size 27. VOLUME DOWN (-) or UP (+) Press to decrease or increase the level of the picture adjustments after the picture select button (PIX) is pressed. 28.
SYSTEM MENU ADJUSTMENTS The System Menu Contains features and options that let you customize your system to change the screen mode display, OSD language and source default. 1) 2) 3) 4) 5) Press the TV button and then the SYSTEM MENU button on the remote, the main page of the system menu will appear on screen. Use the cursor buttons p or q to select the desired item in the main page and press the ENTER button to select. The submenu will appear on screen.
FMM SELECT FMM ON/OFF options - Turns the wireless FM Modulator on or off. FMM SELECT option - Selects the wireless FM Modulator Frequency (CH1 88.1MHz, CH2 88.3MHz, CH3 88.5MHz, CH4 88.7MHz, CH5 88.9MHz, CH6 89.1MHz, CH7 89.3MHz, CH8 89.5MHz, CH9 89.7MHz, CH10 89.9MHz, CH11 90.1MHz, CH12 90.3MHz, CH13 90.5MHz, CH14 90.7MHz, Ch15 90.9MHz, CH16 91.
SOURCE DEFAULT DVD This allows the user to set the system default source to DVD. Note: • If source default is set to ON, every time the unit is turned off then on, the unit will power up and automatically switch the source to DVD. If source default is set to OFF and the unit is turned off then on, the unit will power up in whatever source was last selected. • Unit is set to source default DVD on as the default mode of operation. • Selection of Source default can only be made from within the system menu.
DVD SETTINGS AND ADJUSTMENTS The DVD Setup Menu contains features and options that let you customize your DVD player. For example, you can set a language for the on-screen display or prevent children from viewing DVD playback of adult DVD Titles. Using the Setup Menu 1. Press the DVD button and then the SETUP button on the remote. The Setup Menu appears on the screen as shown per diagram. 2. Use the p or q cursor buttons to highlight the settings to be changed.
DVD SUBTITLE SETUP Select "SUBTITLE" using pqbutton, then press ubutton to enter the submenu. Select the subtitle you desire using pqbutton, then press “ENTER” to confirm the setting. Press tbutton to return. Note: The subtitle selection is only available for discs that are recorded in the above listed languages. If the selected, language is not available, the player will play and display on the screen the original language contained in the disc.
DVD RATING SETUP Parental Language Video Parental : 6.Adult Change Password This item allows you to limit the content of movie playback from G to Adult. The lower the value, the Rating more strict the control. Misc 1. G 2. PG 3. PG – 13 4. R 5. NC – 17 6. Adult The rating level can only be changed when the correct password is provided. For first time use to change parental control, using cursor u button to enter parental mode, key in the default password (3308) and press ENTER.
Load Factory This option allows you to reset all options to factory settings. * This function will not affect the Rating control settings. Language Load Factory Load Factory Video Screen Saver Yes No Rating Screen Saver This option allows you to set the Screen saver mode. ON -Screen saver will appear OFF -Screen saver will not appear Note: The DVD player will enter Screen Saver mode if the unit is inactive for approximately 2 minutes.
Playing MP3 Discs MP3 is a format for storing digital audio. An audio CD-quality song can be compressed into the MP3 format with very little loss of quality, while taking up much less space. CD-R discs that have been encoded in MP3 format can be played on DVD player. The DVD player plays the songs in the order they were burned on to the disc. When playback is started the elapsed time of the track that is playing will be displayed.
Repeat: play repetitively Repeat function has 4 options : Off, Single, Folder, All. Move cursor to Repeat function and press ENTER, Each time ENTER is pressed the unit will cycle through the available options. Off/Single/Folder/All are displayed in that order. Repeat default is Off; 00:00:01 1/12 / 001 Flat Mode 002 Repeat : Off Mode 003 : Normal 004 Off Single Folder All 005 Turn off repeat function Repeat the song being played until STOP is pressed.
00:00:01 Clear program 1/12 Method: To clear the selected song files, press the STOP button twice during playback mode. Move the cursor to the Edit mode function and press ENTER. After Edit mode is selected, move cursor to selected songs list and select the songs which you want to delete. Press ENTER and a check mark will appear to the left of the selected song. Move the cursor to clear program and press ENTER, the selected songs will be deleted from the play list.
DVD Area Code The DVD player is preset to a region code at the factory depending on where the DVD player is sold. A DVD from a different region cannot be played in this unit and the unit will display "WRONG REGION” DVD Basics To get the optimum use out of the DVD section, make sure you read this section completely. Types of Discs your DVD will play • DVD* disc - DVD discs which contain video. • Audio disc - Audio CDs contain musical or sound content only.
TURNING THE UNIT ON OR OFF 1. Pushing in the Screen Release button will unlock the LCD screen and it will drop down slightly. Pivot the screen downward until a comfortable viewing angle is reached. The hinge friction will hold the screen in position while the system is in use. 2. Pressing the power button* on the unit or the remote control will turn the system on and off. When in use the internal backlighting will illuminate the controls. 3.
OVERHEAD DOME LIGHTS The Dome Lights integrated into the unit are controlled by a three position slide switch. Sliding the switch to the ON position will turn the lights ON. The OFF position will prevent the lights from turning ON with the vehicle's interior lighting, and the auto position will allow the lights to turn ON and OFF with the vehicle's interior lighting. Refer to the Installation Guide for wire connections.
TROUBLESHOOTING SOLUTION PROBLEM IR remote inoperative Verify that the batteries in the remote are fresh. Verify that the remote sensor eye is not obstructed. Disc won't play Insert a disc with the label side facing upwards. Check the type of disc you put into disc tray. This DVD only plays DVD, audio CD and MP3. Both the unit and the disc are coded by region. If the regional codes don’t match, the disc can’t be played. Play starts, but then stops immediately The disc is dirty. Clean it.
SOLUTION PROBLEM Not allowed at the moment The feature or action cannot be completed at this time because: 1. The disc’s software restricts it. 2. The disc’s software doesn’t support the feature (e.g., angles) 3. The feature is not available at the moment. 4. 4 requested a title or chapter number that is out of range. Picture is distorted The disc might be damaged. Try another disc. It is normal for some distortion to appear during forward or reverse scan.
REPLACEMENT PARTS Remote Control SPECIFICATIONS 136-4840 LCD Backlighting LED Resolution 800 (RGB) x 480 Pixels 1,152,000 Operation Temperature 32 ~131º F (0 ~ 55º C) Storage Temperature -4 ~ 158º F (-20 ~ 70º C) Backlit life 10,000 Hours Video Display System NTSC / PAL Video Output 1.0 Vp-p @ 75 ohms Power Source 12 VDC Dimension LxWxH 11.0" x 9.5" x 1.7" 289mm x 243mm x 44mm Specifications are subject to change without notice.
ADVENT LIMITED WARRANTY Applies to ADVENT Mobile Video Products R AUDIOVOX ELECTRONICS CORP. (the Company) warrants to the original retail purchaser of this product that, should this product or any part thereof (except game controllers), under normal use and conditions, be proven defective in material or workmanship within 36 months from the date of original purchase, such defect(s) will be repaired or replaced with reconditioned product (at the Company's option) without charge for parts and repair labor.
© 2011 ADVENT, 150 Marcus Blvd.
