VOL TUNE/ SKIP/ TRACK VOL CLAS POP ROCK MP3 ST PTY ME/CR EON LOC SW LOUD AF TA TP MONO REC TAPE IN CDP P-945W LEVEL METER AM/FM/MPX RADIO WITH DETACHABLE FRONT PANEL, COMPACT DISC PLAYER, CD CHANGER CONTROLS AND QUARTZ CLOCK OWNER'S MANUAL Released 3-27-02.
INDEX Page Operating Instructions ................................................................ 3 - 9 Specifications ............................................................................... 10 CD Changer Controls ................................................................... 11 Setting the Clock .......................................................................... 12 CD Player Error Codes ................................................................. 13 CD Changer Error Codes ........
OPERATING INSTRUCTIONS 30 32 31 14 26 15 23 25 22 24 27 33 11 16 17 36 37 VOL TUNE/ SKIP/ TRACK VOL 9 CLAS POP ROCK MP3 ST PTY ME/CR EON LOC SW LOUD AF TA TP MONO REC TAPE IN CDP LEVEL METER 2 18 3,4,5,6,7 8,10 12 21,38 19,39 20,40 29,35 28,34 1 POWER ON/OFF BUTTON Press this button to turn the unit on or off. If the unit is off and the ignition switch is "on", the unit will turn on automatically when a disc is inserted, or when the MODE switch or BAND switch is pressed.
normal indication 5 seconds after the last adjustment or when another function is activated. 5 TREBLE CONTROL To adjust the treble level, first select the Treble mode by pressing the SEL button so that the TRE indication appears on the display panel. Within 5 seconds of choosing the Treble mode, press the AUDIO ADJUST VOL or button to adjust the treble response as desired. The treble level will be shown on the display panel from a minimum of -10 to a maximum of +10 (00 is flat response).
FM3 will appear on the display panel according to your selection. cs to return to disc play from the beginPress the Mode button ning of the last track in play. bm MANUAL UP/DOWN TUNING (+ SEEK TUNING / -) / AUTOMATIC The radio tuning function is normally in automatic seek tuning mode. The radio will seek the next available station and stop at that frequency. The Seek function can be stopped by pressing the button again. The radio will return to the last tuned frequency.
button is pressed within one second. Similarly, with each momentary tap of the Backward Track Select button ( - ), the next lower track number will be selected if the button is pressed within one second. bp LIQUID CRYSTAL DISPLAY PANEL FUNCTIONS The Liquid Crystal Display (LCD) panel displays the frequency, time, and all activated functions, including five bar graphs which provide a visual representation of the audio signal.
cl SHUFFLE PLAY SELECTOR (SHF) co TIME/FREQUENCY SELECTOR (T/F) During disc play, press this button to play the tracks on the disc in a random or shuffled order (SHF) will appear on the display panel). In Random Play mode, pressing the Forward Track Select (+ ) or the Backward Track Select ( -) will also select tracks in a random order instead of the normal progression. Additional presses will select tracks in random order.
dl cr LOCAL/DISTANT (LOC) SELECTOR This feature is used to select the strength of the signals at which the radio will stop during Automatic Seek Tuning. Pressing and holding this button will select the Local setting (LOCAL will appear on the display panel) and only strong (local) stations will be received. Pressing the button again will select the normal Distant setting (Dx will appear on the display panel). The radio will stop at a wider range of signals, including weaker (more distant) stations.
NOTES ON USE OF FRONT PANEL DETACHING THE FRONT PANEL 1. Make sure the front panel is right-side-up when attaching it to the chassis as it cannot be attached when up-side down. 2. Do not press very hard on the front panel when attaching it to the chassis. No more than light to moderate pressure should be needed. 3. When attaching the front panel, make sure the right side is correctly engaged before pressing the left side to lock it into position. 4.
SPECIFICATIONS Size: 7" W x 2" H 178 mm x 50 mm x x 6-5/8" D 168mm Operating Voltage: 12 volts DC, negative ground Output Power: 160 watts maximum (40 watts x 4 channels) Output Wiring: Floating-ground type designed for 4 speaker use. Front and rear channels CANNOT be combined (bridged) for use with 2 speakers. RCA low-level outputs (rear channels). Output Impedance: Compatible with 4 ohm speakers. Low-Level Output: 1.0 volt (1,000 mv.) Tuning Range: AM: 530 - 1,710 kHz. (10 kHz.
CD CHANGER dr TRACK SELECT (+ CONTROLS Built into this radio are controls to operate an optional CD changer. Please check with your Rampage/Audiovox car stereo specialist or call 1-800-645-4994 for recommendations of the models that will work with this radio. Adjustment of the audio functions (volume, tone, balance, and fader) for the CD changer operate in the same manner as they do for radio play. The following controls will operate the CD changer when it is installed and connected to this radio.
a desired disc is reached, press the Scan button again and play of the selected disc will continue ( DSN will disappear from the display panel). The Disc Scan mode will also be canceled by activating the (Repeat Play or Random Play functions).
OR CODES CD PL A YER ERR ERROR If a problem should develop while operating the CD player, an error code (ER-1, ER-2, ER-3, etc.) may appear on the display panel. This can indicate a number of problems with the unit, including a mechanical error or an error in the microprocessor control of the player. If an error code should appear, try ejecting and re-loading the disc into the player. While the disc is out of the unit, make sure it is clean, undamaged, and loaded correctly (label surface up).
l Do not attempt to open the unit chassis. There are no user serviceable parts or adjustments inside. l When the vehicle warms up during cold weather or under damp conditions, moisture may condense on the lens of the disc player. Should this occur, the player will not operate properly until the moisture has evaporated. l The unit is designed with a vibration dampening CD mechanism to minimize interruption of disc play due to normal vibration in a moving vehicle.
12 / 24 MONTH LIMITED WARRANTY Applies to automotive radios, radio/tape players, radio/CD players, CD changers, power amplifiers, equalizers and accessories.
© 2002 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y.