Owner`s manual

Parameter Adjustment Procedure

1. Enter Picture Quality Setting Mode:

Press the PIC button (24) on the remote control or the BAND/PC button (4) on the monitor.

2. Select Item to Set:

Press the AUDIO button (5) on the control panel to select “BRIGHT” or “CONTRAST”.

3. Set Parameters:

Press the +/– buttons (15, 16) on the remote or turn the rotary encoder (5) on the control panel.

4. Exit Picture Quality Setting Mode:

Press the PIC button (24) on the remote control or the BAND/PIC button (4) on the monitor

Table 2: Video Output Modes

* CVBS - Composite Video Baseband Signal

Parking Brake Inhibit

• When the “PRK SW” cable is connected to the brake switch, the display on the TFT monitor will display video only when the vehicle is applied.

• Parking brake function is overridden when the video source is set to CAMERA.

• When the parking brake inhibit is active, the front monitor displays “Parking Is On”, preventing the driver from watching content while driving.

Rear video screens are not affected.

Mute

Press the MUTE button on the front panel (6) or remote control (3) to mute the volume from the unit. Press the MUTE button again to restore the

volume. “MUTE” is displayed on the LCD. Adjusting the volume or using any of the audio setup features cancels the mute function. External peri-

pheral devices can be connected to this unit via RCA output or MediaLink. Select “AUX” mode to access and control connected auxiliary devices.

Monitor Movement Mechanism

If an obstruction occurs in the monitor path, the following protective measurements can be executed to prevent damage to the mechanism or

monitor:

After the protective procedure is executed, normal operation is resumed by pressing the OPEN button (1) or disconnecting and reconnecting the

power.

Table 3: Monitor Protective Measures

Subject to technical changes

Playing Source Video Output Modes

AM/FM TUNER RGB Mode

DISC RGB Mode

AUX 1 + 2 CVBS Mode

NAV RGB Mode

CAMERA CVBS Mode

Obstruction Self Protection OPEN Button Pressed Power Reconnected

Monitor loading out horizontally Unit stops at obstruction point Monitor fully extended

horizontally

Monitor is automatically loaded into unit

Monitor loading in horizontally Unit stops at obstruction point Monitor fully extended

horizontally

Monitor is automatically loaded into unit

Monitor loading out horizontally Unit stops at obstruction point Monitor swivels back to the unit Monitor swivels back to the unit

Monitor loading in horizontally Unit stops at obstruction point Monitor swivels back to the unit Monitor swivels back to the unit