OWNER'S MANU AL MANUAL AND INST ALLA TION GUIDE INSTALLA ALLATION MODEL SU-101 SUB-WOOFER SPEAKER SYSTEM WITH DUAL SATELLITE TWEETERS
INTRODUCTION Congratulations on your purchase of the Rampage High Performance vehicle Sub-woofer System. High quality Bass reproduction, coupled with dual tweeters, allows your car's audio system perform to its full potential. TOLL-FREE ASSISTANCE The installation and connections are so simple we doubt you’ll need our help, but if you do, we’re here to help you. Just call our toll-free assistance line at 1-800-645-4994 during the days/hours shown. DAY PACIFIC MON. - FRI.
PACKING LIST Installation of your SU-101 is easy and everything you need is included in this package. Open it up, lay out the parts and you are ready to get started.
Placing the System 1. Mount the subwoofer enclosure in either the Rear Cargo Area (for Vans, SUVs and Hatchbacks) or in the trunk (for sedans). 2. Mount the tweeters on the vehicle interior, high up for maximum sound and facing forward for optimum usage. Important Installation Warnings 1. NEVER attempt to install this system in the area above the vehicle fuel tank. Drilling mounting holes could pierce the fuel tank. 2.
INSTALLATION SUB-WOOFER ENCLOSURE The SU-101 sub-woofer enclosure is designed for horizontal (flat) mounting. It must never be mounted upside-down or on either of it's sides. The most convenient area for enclosure installation is within the trunk of cars, such as sedans, or on the rear cargo area of vans and SUVs. It is also possible to mount the unit behind the front seat area of utility and pick-up trucks if space allows. The following procedure outlines the basic installation criteria for the enclosure.
SATELLITE TWEETER SATELLITE TWEETERS CONFIGURATION: Normally, the satellite tweeter each is supplied with the bracket and lanyard wire attached as shown in the drawing to the right. If the speaker is not assembled as shown, assemble the swivel bracket and lanyard to the speaker as illustrated. The bracket, lanyard and screws are packed with each speaker.
WIRING INSTRUCTIONS The power connections for the SU-101 enclosure are made via a screw- tightened terminal block. Simply loosen the screw fully insert the wire or spade lug under the respective terminal screw, then tighten the screw to secure the lug. 1. Power Connection The battery terminal (B+) must be connected directly to the positive terminal of the vehicle battery to provide an adequate voltage source and minimize noise.
SU-101 SPEAKER SYSTEM INTERCONNECTION WIRING DIAGRAM LEFT CHANNEL SATELLITE TWEETER RED (+) RIGHT REAR RIGHT CHANNEL SATELLITE TWEETER BLACK (-) RED (+) GROUND (BLACK) EXISTING VEHICLE REAR SPEAKERS CHASSIS (VEHICLE) GROUND RIGHT REAR SPEAKER LEFT REAR SPEAKER LEFT REAR BLACK (-) RIGHT FRONT BLACK ( - ) TO FRONT SPEAKERS (WHEN USED) RED ( + ) RED RED ( + ) BLACK ( - ) LOW-LEVEL RCA OUTPUTS LEFT FRONT IMPORTANT USE EITHER HIGH LEVEL OR LOW LEVEL INPUT NOT BOTH 10-PIN CONNECTOR RCA TYPE
USE OF CONTROLS 1 2 13 3 12 4 5 11 1 ON LED INDICATOR This indicator lights green when the system is powered up and operating normally. 2 FAIL LED INDICATOR This indicator lights red when a system failure occurs activating the overvoltage protection circuit. 3 PHASE SELECT SWITCH This slide switch is used to change the phase of the reproduced sound output from the SU-101 Speakers to match the phase of the audio receiver system.
TROUBLESHOOTING An error made in operation or during installation of this product may be mistaken for a system malfunction. Please perform the checks described below before contacting your dealer or service facility. Symptom Remedy Possible Cause No power Blown fuse Check fuses in vehicle fuse box and SU-101 system. Replace as necessary with fuse of same type and rating as original. If fuse blows again, consult with service facility. Incorrect connection Check all wiring and correct as necessary.
90 DAY LIMITED WARRANTY AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 90 days from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor.