User Guide

INSTALLING THE CD MODULE (NGMCD2)

CAUTION: DO NOT INSERT CD UNTIL THE RADIO CONFIGURATION

IS COMPLETE! Refer to page 11 configuration instructions.

CD1. For installation of CD module (NGMCD2), follow steps 1-3 on page

Insert the CD Module into the Nextgen chassis until it clicks in

place.

CD2. Connect the 14-pin connector from the CD module to the Nextgen

chassis on the bottom left corner 14-pin socket.

CD3. Connect the 4-pin connector from the Nextgen CD Module to the 4-

pin socket on the backside of the faceplate.