P-25 ELECTRONICALLY-TUNEDAM/FM/MPXRADIO WITHAUTO-REVERSECASSETTEPLAYER ANDQUARTZCLOCK OWNER'S MANUAL
OPERATING INSTRUCTIONS 3 BASS CONTROL (PULL) 1 ON-OFF SWITCH/VOLUME CONTROL Rotate this knob clockwise to turn the radio on. Continue rota- Pull this knob outward until it locks into position and rotate it tion until the desired volume level is obtained. Rotate the knob fully counter-clockwise to turn the unit off. 2 TREBLE CONTROL (PUSH) Push this knob in and rotate it clockwise to increase treble response, counter-clockwise to decrease treble response.
5 FRONT/REAR FADER CONTROL Rotate this knob to the left or right to fade the sound between the front and rear speakers in 4 speaker installations. A detent click can be felt at the center of rotation. When used in conjunction with the Left/Right Balance Control , you have full 4way stereo balance capability. In 2 speaker installations, rotating the Fader Control will have no effect on the speaker output. 4 the radio will stop during Automatic Seek Tuning.
bm STATION PRE-SET MEMORIES To set any of the 6 pre-set memory buttons, use the following procedure: 1. Turn the unit on and select the desired band. 2. Select the first station to be pre-set using the Manual Up/Down or Automatic Seek Tuning functions. 3. Press the pre-set button to be set and continue to hold the button in. The volume will momentarily mute and then return and the pre-set number will appear on the display panel.
NOTE: Never leave a cassette engaged in the player when not in use. Doing so can cause damage to the cassette and/or mechanism of the unit. Always press the eject button and remove the cassette before leaving the vehicle. bt CD/AUXILIARY INPUT SELECTOR (CD) An auxiliary input jack is provided on the rear of this unit to ac- bu TIME/FREQUENCY SELECTOR (T/F) During radio or CD/Auxiliary Input operation, press this button to call the time display on the incorporated quartz clock.
SPECIFICATIONS Size: 7" W x 2" H x 5 1/2" D 178 mm x 50 mm x 140 mm Operating Voltage: 12 volts DC, negative ground Output Power: 50 watts maximum (25 watts x 2 channels) Output Wiring: Floating-ground type design for 4 speaker use. May also be used with 2 speakers. RCA low-level outputs Output Impedance: Compatible with 4-8 ohm speakers Low-Level Output 500 mv. Tuning Range: AM: FM: 530 - 1,710 KHz. (10 KHz. step) 87.5 - 107.9 MHz. (200 KHz. step) Sensitivity: AM: FM: 20 uv. 1.5 uv.
CARE AND MAINTENANCE The radio portion of your new sound system does not require any maintenance. We recommend you keep this manual for future reference of the many features found in this unit. As with any cassette player, the cassette section of this sound system does require a minimum of maintenance to keep it in good working condition. The following simple care and maintenance suggestions should be followed to prevent malfunctions of the cassette system. CASSETTE CARE: 1.
12 MONTH LIMITED WARRANTY Applies to automotive radios, radio/tape players, radio/CD players, CD changers, power amplifiers, equalizers and accessories.
