P-950WESP P-950W ESP OPEN Sub. W CLAS POP EQ ILL PWR CD-R/RW PLAYBACK Tune /Seek JAZZ LOC T/F REG MONO AF TA ST TP LOUD SEL SCAN AS/PS PTY ME/CR MULTI-COLOR FLOURESCENT DISPLAY MUTE MONO /Track EON POWER LEVEL METER LOC 1 PAU 2 SCN 3 RPT 4 SHF 5 D.DN 6 D.
INDEX Page Operating Instructions ............................................................... 3 - 9 Setting the Clock .......................................................................... 9 CD Player Error Codes................................................................. 9 Specifications ..............................................................................10 CD Changer Controls ..................................................................11 CD Changer Error Codes.................
OPERATING INSTRUCTIONS 2 33 P-950W ESP OPEN 29 ILL PWR CD-R/RW PLAYBACK Sub. W CLAS POP EQ 19, 27, 31, 32 (BEHIND PANEL) 11, 20, 21, 37, 38 16 17 Tune /Seek JAZZ LOC T/F REG 28 MONO AF TA ST SCAN 9 14 12 13 POWER LEVEL METER LOC 1 SEL AS/PS PTY ME/CR MULTI-COLOR FLOURESCENT DISPLAY MUTE 1 MONO /Track EON TP LOUD 34 PAU 2 3 SCN 22 23 39 4 RPT 24 40 SHF 5 25 41 D.DN 6 D.
BASS CONTROL To adjust the bass level (Equalizer function inactive), first select so the BAS indication the Bass mode by pressing the SEL button appears on the display panel. Within 5 seconds of choosing the Bass mode, press the AUDIO CONTROL button to decrease AUDIO CONTROL button to increase the bass response, or the it as desired. The level will be shown on the display panel from a minimum BAS -10 to a maximum of BAS +10 (BAS 00 indicates flat response).
bl conditions, the unit should be left in the stereo mode as indicated by the ST indication on the display panel when tuned to an FM stereo signal. If the stereo signal is too noisy for comfortable listening, press the MONO button to switch to mono reception (the ST indication will disappear from the display panel, and MONO will be displayed). To return to stereo reception mode, press the button again so that the ST indication reappears in the display.
and two beeps will sound, indicating that the station is now set into that preset memory position. The station can now be recalled at any time by pressing that button. 4. Repeat the above procedure for the remaining 5 pre-sets on that band and for the other 4 bands on the unit. br VACUUM FLUORESCENT DISPLAY (VFD) The Vacuum Fluorescent Display (VFD) panel displays the frequency, time, and activated functions using one of three .
cn PAUSE (PAU) BUTTON The Pause function is used to freeze disc play when the CD player or optional CD changer is in use. PAUSE will appear on the display. Press this button again to resume disc play; the PAUSE indication will disappear. co TRACK SCAN (SCN) SELECT During disc play, press this button to play the first 10 seconds of each track on the disc (SCN) will appear on the display panel).
dl PRE-SET SCAN (PS) /AUTO-STORE TUNING (AS) Press this button momentarily to scan the stations pre-set into the six memories of the current band in use. The unit will stop at each pre-set station for 5 seconds before continuing to the next pre-set station (the pre-set number on the display panel will flash during Pre-Set Scan operation). Press the button again momentarily to stop Pre-Set Scan operation and remain on the selected frequency.
THEFT DETERRENT LED (31) DISC SLOT (19) RESET BUTTON (32) MOUNTING PLATE GUIDE (2 PLACES) PANEL MOUNTING PLATE CD EJECT BUTTON (27) FRONT PANEL SETTING THE CLOCK 1. Switch the vehicle ignition and radio “on”. 2. Press the Display (T/F) button to call the time display; then press and hold the button until a beep tone occurs and the time display flashes. ) button to adjust the hours and AM/PM indication, or the 3.
SPECIFICATIONS Size: 7" W x 2" H x 6-5/8"D 178 mm x 50 mm x 168 mm Output Impedance: Compatible with 4 – 8 ohm speakers. Operating Voltage: 12 volts DC, negative ground Fuse Ratings: Constant (Yellow wire): 15 AMP. Switched (Red wire): 0.5 AMP. Low-Level Output: Tuning Range: Output Power: 160 watts maximum (40 watts x 4 channels) 1.0 V AM: 530 – 1,710 kHz. (10 kHz. step) FM: 87.5 – 107.9 MHz. (200 kHz. step) Sensitivity: Output Wiring: Floating-ground type designed for 4 speaker use.
dt CUE/REVIEW FUNCTIONS ( CD CHANGER CONTROLS Built into this radio are controls to operate an optional CD changer. Please check with your Prestige/Audiovox car stereo specialist or call 1-800-645-4994 for recommendations of the models that will work with this radio. Adjustment of the audio functions (volume, tone, balance, and fader) for the CD changer operate in the same manner as they do for radio play. The following controls will operate the CD changer when it is installed and connected to this radio.
be continually repeated until the Disc Repeat mode is canceled by pressing the RPT button again or by activating the Scan or Shuffle Play functions. em DISC/TRACK SHUFFLE PLAY (SHF) When the SHF button is pressed, the SHF indication will appear on the display panel and the tracks on the disc will be played in a random, shuffled order. The Track Select button will also select tracks in the shuffled order instead of the normal progression.
cl ds except WIRELESS REMOTE CONTROL OPERATION CD TRACK SELECT – See Main Unit and press to select a higher track number, press lect a lower track number. The wireless remote control supplied with this model is capable of operating most of the features of the unit from a remote location. Each button on the remote control functions in the same way as the referenced button on the main unit.
16 14 1 MODE OWER 3 CARE AND MAINTENANCE SEL T/F S BA ND 2 15 5 6 13 AS/PS 4 10 12 11 PAU SCN RPT 1 2 3 SHF D.DN D.UP 4 5 6 7 8 9 INFRARED REMOTE CONTROLLER 17 (FAR SIDE) The radio section of your new sound system does not require any maintenance. We recommend you keep this manual for reference on the many features found in this unit as well as how to set the clock.
Should this occur, the player will not operate properly until the moisture has evaporated. l The unit is designed with a vibration dampening CD mechanism to minimize interruption of disc play due to normal vibration in a moving vehicle. When driving on very rough roads, however,occasional sound skips may occur. This will not scratch or damage the disc and normal play will resume when the rough conditions cease.
12 / 24 MONTH LIMITED WARRANTY Applies to automotive radios, radio/tape players, radio/CD players, CD changers, power amplifiers, equalizers and accessories.
