User manual
Wiring
the
Camera
to the Vehicle's
Reverse
Lamn
I.Locate
the
reverse
lamp
in the
taillight
assembly.
2.Using
the tap
connector
supplied,
perform
the
following
steps:
a)
Place
the
un-stripped
positive
lead
from the
tail
lamp
in
the
run
channel,
which
runs
completely
through
the
connector.
b)
Insert
the
un-stripped
red
power
wire
from the
camera
completely
into the
other
channel
in the connector.
c)
Make
the
connection
between
the
wires
by
crimping
down
the metal
connector
with
a
pair
of
pliers,
making
sure the
metal
is flush with
the
plastic
insulator.
d) Close the top
plastic
hinged
cover
until latched.
3.Attach
the
black
wire
from the
camera
to the
negative
lead
of
the lamp
by
repeating
the
above
procedure.
~
~
~
J
Operating
the
System
The
Wireless Vehicle
Rear
Observation
System
operates
when
the
vehicle
is
shifted
into
reverse.
The
Camera
transmits
a
clear
and
wide
image
from the
area
behind
the
vehicle
to the
Monitor
inside
the vehicle.
The
monitor,
when
powered,
remains
in sleep
mode
until
it
receives
a
video
signal
on
the
2.4GHz
frequency.
When
the
monitor
receives
a
video
signal, it
automatically
turns
on and
displays
the
image
from the
camera.
The
monitor
automatically
adjusts
for color,
brightness,
and
contrast,
for
either
daytime
viewing
or
night
time
viewing.
There
are
no
user
selectable
adjustments.
In
conditions
such
as at night, the
camera
will
automatically
switch
to
Night
Vision
Assisted
Mode.
The
picture
will
look
more
like
a
Black
&
White
image, this is
due
to the
low
light
level
and
is
normal.
Note:
Because
this is a
wireless
system,
the
monitor
is
always
watching
for a video signal.
It
is
possible
to
receive
signals
from
other
cameras.
Systems
such
as
Security
camera's,
Baby
monitors,
and
even
other
Back
up
camera
systems
can
trigger
the
monitor
to
briefly
turn
on.
This
is
normal
for
wireless
products.
8