OPEN 9 Sub. W CLAS POP EQ ILL PWR CD-R/RW/MP3 PLAYBACK P-953ESP Tune /Seek JAZZ T/F 0 LOC REG MONO AF ST TA EON TP LOUD MONO /Track 8 PTY AS/PS MP3 ME/CR P-953ESP POWER LEVEL METER MUTE SCAN SEL ENTER 7 LOC 1 PAU 2 SCN 3 RPT 4 SHF 5 D.DN 6 D.
INDEX Page Operating Instructions ................................................................ 3 - 9 Setting the Clock ........................................................................... 9 CD Player Error Codes .................................................................. 9 Specifications ............................................................................... 10 CD Changer Controls ................................................................... 11 CD Changer Error Codes ........
OPERATING INSTRUCTIONS 33 2 OPEN 29 19, 27, 31, 32 11, 20, 21, 37, 38 (BEHIND PANEL) 16 17 Tune /Seek JAZZ T/F 0 LOC REG 28 AF MONO TA MONO /Track EON TP ST 1 9 Sub. W CLAS POP EQ ILL PWR CD-R/RW/MP3 PLAYBACK P-953ESP 34 8 PTY AS/PS MP3 13 ME/CR LOUD POWER LEVEL METER MUTE SCAN 1 PAU SEL 9 14 12 ENTER 7 LOC 2 3 RPT SCN 22 23 39 4 SHF 24 40 5 6 D.UP D.
BASS CONTROL To adjust the bass level (Equalizer function inactive), first select so the BAS indication the Bass mode by pressing the SEL button appears on the display panel. Within 5 seconds of choosing the AUDIO CONTROL button to Bass mode, press the AUDIO CONTROL button decrease the bass response, or the to increase it as desired. The level will be shown on the display panel from a minimum BAS --10 to a maximum of BAS 10 (BAS 00 indicates flat response).
disc play, pressing this button will mute disc audio. During this indication will remain on the display panel to show time, the that a disc is still loaded in the unit. bl AM/FM BAND SELECTOR (BAND) Each time the BAND/LOUD button is pressed momentarily, the radio band is changed. The indication AM, F1, F2 or F3 will appear on the display panel according to your selection.
4. Repeat the above procedure for the remaining 5 pre-sets on that band and for the other 3 bands on the unit. br VACUUM FLUORESCENT DISPLAY (VFD) The Vacuum Fluorescent Display (VFD) panel displays the frequency, time, and activated functions using one of three illumination levels as selected by the PWR/ILL button . 1 bs POWER LEVEL METER DISPLAY This display consists of a left and right six-bar graph which provides a visual representation of the audio signal level.
cn PAUSE (PAU) BUTTON The Pause function is used to freeze disc play when the CD player or optional CD changer is in use. S--PAUSE will appear on the display. Press this button again to resume disc play from the point at which it was stopped and S--PAUSE will disappear. co TRACK SCAN (SCN) SELECT During disc play, press this button to play the first 10 seconds of each track on the disc (S--SCN) will appear on the display panel).
dl PRE-SET SCAN (PS) /AUTO-STORE TUNING (AS) Press this button momentarily to scan the stations pre-set into the AM band, or the six memories of each FM band. The unit will stop at each pre-set station for 5 seconds before continuing to the next pre-set station (the pre-set number on the display panel will flash during Pre-Set Scan operation). Press the button again momentarily to stop Pre-Set Scan operation and remain on the selected frequency.
NOTES ON USE OF REMOTE RCA INPUT JACKS: THEFT DETERRENT LED (31) DISC SLOT (19) The remote RCA input jacks provide the user option of applying an external audio source to the radio.The audio jacks are compatible with most CD and cassette players, or an MP3 digital audio playback unit. When the external source is connected, only that media is played by the radio when the AUX input is selected by the MODE button; no other input sources (radio or CD) are operative.
SPECIFICATIONS Size: 7" W x 2" H x 6-1/4"D 178 mm x 50 mm x 158 mm Output Impedance: Compatible with 4 – 8 ohm speakers. Low-Level Output: 0.7 Volt. Tuning Range: AM: 530 – 1,710 kHz. (10 kHz. step) FM: 87.5 – 107.9 MHz. (200 kHz. step) Operating Voltage: 12 volts DC, negative ground Fuse Ratings: Constant (Yellow wire): 15 AMP. Switched (Red wire): 0.5 AMP.
CD CHANGER CONTROLS Built into this radio are controls to operate an optional CD changer. Please check with your Prestige/Audiovox car stereo specialist or call 1-800-645-4994 for recommendations of the models that will work with this radio. Adjustment of the audio functions (volume, tone, balance, and fader) for the CD changer operate in the same manner as they do for radio play. The following controls will operate the CD changer when it is installed and connected to this radio.
will be continually repeated until the Disc Repeat mode is canceled by pressing the RPT button again or by activating the Scan or Shuffle Play functions. em DISC/TRACK SHUFFLE PLAY (SHF) When the SHF button is pressed, the SHF indication will appear on the display panel and the tracks on the disc will be played in a random, shuffled order. The Track Select button will also select tracks in the shuffled order instead of the normal progression.
cl WIRELESS REMOTE CONTROL OPERATION The wireless remote control supplied with this model is capable of operating most of the features of the unit from a remote location. Each button on the remote control functions in the same way as the referenced button on the main unit. For optimal operation of the remote control, always aim it toward the Remote Sensor on the front panel of the main unit.
PLAYING MP3 MUSIC FILES 16 14 1 7 3 15 MODE OWER 0 SEL T/F EN T ER BA N S 5 MP3 CONTROLS The following buttons represent control inputs, characters and/or numbers dedicated to the access of files on your MP3 CD. 6 1. AS/PS: The AS/PS button, also labeled MP3, is used to search and/or access the Track Number and Directory/Album title; additional presses will momentarily access the disc serial number (if applicable), and display the current Directory/Album title.
14 11 OPEN 9 Sub. W CLAS POP EQ ILL PWR CD-R/RW/MP3 PLAYBACK P-953ESP Tune /Seek JAZZ T/F 0 LOC REG MONO AF ST TA EON TP LOUD MONO 1 /Track 8 PTY AS/PS MP3 ME/CR POWER LEVEL METER MUTE 13 SCAN 12 3 ENTER 7 LOC 1 PAU SEL 2 3 RPT SCN 6. Preset 4: This button functions in the same manner as Preset 1, except it represents alphanumeric characters J, K, L, 4. 7.
4. Then continue the search within the directory for the song title by using the / buttons, but use the button first. 5. When the title is accessed, press the ENTER button again to begin play of the selected song. ACCESSING THE ID TAG To access the ID tag, when supported, proceed as follows: 1. Press the MP3 (AS/PS) button until the ID Tag, if supported, is displayed. NOTE: The ID TAG can specify the Songname, Artist, Album, Year, and/or Comments. 2.
NOTES ON DISCS: Attempting to use non-standard shape discs (e.g.; square, start, heart) may damage the unit. Be sure to use round-shape CDs only in this unit. NOTES ON CD-Rs (Recordable CDs)/CD-RWs (Rewriteable CDs): 1. Be sure to use discs with the following marks only for play in this unit: 2. The unit cannot play a CD-R or CD-RW that is not finalized. (Please refer to the manual of your CD-R/CD-RW software for more information on the finalization process.) 3.
CARE AND MAINTENANCE ! The radio section of your new sound system does not require any maintenance. We recommend you keep this manual for reference on the many features found in this unit as well as how to set the clock. The compact disc player section also requires no routine maintenance, but proper understanding of its use and handling will help you obtain maximum enjoyment of its capabilities.
12 / 24 MONTH LIMITED WARRANTY Applies to automotive radios, radio/tape players, radio/CD players, CD changers, power amplifiers, equalizers and accessories.
© 2003 AUDIOVOX ELECTRONICS CORP.