3 Channel Remote Start/Keyless Entry System Installation Instructions

WIRING CONNECTIONS: 12 Pin Input / Output Harness

Black Wire: Chassis Ground Source

Connect the Black wire to a known vehicle ground source or to a solid clean metal part of the chassis. Be

certain to remove any paint or grease and secure this wire with a self taping screw and ring terminal.

BLACK w/WHITE Tracer Wire: Control Switch

The Black w/ White tracer wire provides ON-OFF control of the Remote Starter.

When the Black w/ White wire is switched to a full time ground, the PRO-9175FT Remote Start Module is

operative. When the Black w/Whitewire is at opencircuit throughthe controlswitch,the remote starter isdisabled.

Connect the Black w/ White tracer wire to one of the wires from the back of the previously mounted control

switch. Connect the remaining wire of the control switch to chassis ground. Always try to mount the switch

so that the ON position is in an upward or toward the driver direction.

GREY Wire: Negative Inhibit Input 1

Connect the GREY wire to the previously mounted hood pin switch provided . This wire will be routed through the

fire wall into the engine compartment. It is necessary to use an existing grommet when passing wires through the

fire wall to prevent short circuiting. This is an important safety feature of 9175, and failure to use this feature can result

in serious injury. Route the wire to the pin switch and connect it using the bullet connector provided.

GREY w/ BLACK Tracer Wire: Negative Inhibit Input 2

Any time the grey w/ black tracer wire is grounded, the Remote Starter will stop operating, even if the signal

is received from the transmitter.

If the brake light switch in the vehicle switches ground to the brake light circuit, connect the Grey w/ Black

trace wire to the output of the brake light switch. If the brake light switch in the vehicle switches +12 Volts,

do not use the Grey w/ Black wire; see Brown w/ Black tracer wire.

BROWN Wire: Positive Inhibit Input 1

Any time + 12 Volts is applied to the Brown wire, the Remote Starter will stop operating, even if the signal is

received from the transmitter.

If the vehicle has a factory installed hood pin switch, and that switch provides + 12 Volts to an under hood light,

the Brown wire can be connected to the existing pin switch.

BROWN w/ BLACK Tracer Wire: Positive Inhibit Input 2

Any time + 12 Volts is applied to the Brown w/ Black tracer wire, the Remote Starter will stop operating, even

if the signal is received from the transmitter. If the brake light switch in the vehicle switches + 12 Volts to the

brake light circuit, connect the Brown w/ Black trace wire to the output of the brake light switch. If the brake

light switch in the vehicle switches ground, do not use the Brown w/ Black wire; see Grey w/ Black tracer wire.