Vehicle Alarm System Installation Manual

Programmable Features:

Features 1 Chirp 2 Chirp Default

First Passive Arming Active Arming Passive Arming

Second Ignition D/L ON Ignition D/L OFF Ignition D/L OFF

Third Ignition D/UL ON Ignition D/UL OFF Ignition D/UL OFF

Fourth Passive D/L Active D/L Active D/L

Fifth Chirps ON Chirps OFF Chirps ON

To Program These Features:

Entering the Programming Mode involves operating the Ignition Switch and the Valet/Program/Manual Override

Switch in a particular sequence. This sequence is very time dependent, in other words it must be performed

quickly in order for you to enter the mode. This sequence is also only one step different from the Transmitter

Programming Mode, so make cert ain you perform the sequence properly.

Upon entering the Programming Mode, the system is immediately set to allow adjustment of the First

Programmable Feature. That First feature, "Passive or Active Arming", can then be set ON or OFF by

pressing button 1 of the transmitter. The system confirms that it is set to adjust the First feature by

repeatedly flashing the LED once, with a pause in between each flash. The system will then report how the

feature has been set by the number of chirps heard after pressing the transmitter button. Toggling the Valet/

Program/Manual Override Switch once again will advance you to the Second Programmable Feature,

confirmed by a repeating two LED flashes, with a pause in between each flash, etc., etc.

It is important to note that when you first enter the Programming Mode, you are automatically positioned to

adjust the First Programmable Feature, and that the Valet/Program/Manual Override Switch allows you to

toggle from there through each of the four more programmable features. However, it will not allow you to

return to any feature once you have toggled past it. Should you accidentally toggle past the feature you

wanted to program, you must exit and re-enter the Programming Mode and then adjust the feature you missed.

It is also important to note that you may toggle past as many programmable features as you wish without

having to adjust them. Each time you toggle forward to a new feature, the siren will chirp the appropriate

number of times (1 or 2 times) to indicate how that feature is currently set, and the LED will flash the

appropriate number of times to indicate the number of the feature (First through Fifth) that you are set to

adjust. For example, you might enter the mode and toggle the Valet/Program/Manual Override Switch 3

times in order to adjust the Fourth programmable feature. The system would respond with 1 Chirp, and the

LED would begin to flash 4 Flashes, pause, and repeat. This has told you that the system is ready for you

to adjust the Fourth programmable feature, and that it is currently programmed for Chirps ON. A single

press of button 1 of the transmitter will cause the system to produce 2 Chirps. This signifies that you have

changed the programming to Chirps OFF. Please follow the programming procedure carefully, and refer to

the list of the Programmable Features above when programming the PRO 9842.