Installation Manual

128-9324
8 of 12
Page 8
the two inputs Arm #1 & Arm #2. If both inputs are active at the same time, the vehicle will not arm. The
intent of this wire is to prevent the system from arming when the in vehicle door lock switch is used to lock
the doors, insuring only the transmitter arms the system. If you do not desire this feature or the customer
prefers that the door lock switch arm the system as well as the transmitter, connect this wire to chassis ground.
RED WIRE : DISARM INPUT #1
Connect this wire to the driver's door unlock motor wire, which will receive a negative or positive pulse when
the drivers door is unlocked with the remote transmitter, and the door switch, but does not receive a pulse
when all doors are unlocked using the remote transmitter.
GREEN WIRE : ARM INPUT #1
Connect this wire to the lock side of the door lock/unlock switch or, the driver's door lock motor leg wire,
which will receive a negative or positive pulse when the doors are locked using the door switch or the remote
transmitter.
RED w/BLACK TRACE WIRE : DISARM INPUT #2
Connect this wire to the unlock side of the door lock/unlock switch or any passenger door unlock motor wire,
which will receive a negative or positive pulse when all doors are unlocked using the door panel switch or
the remote transmitter, but will not receive a pulse when the driver only door is unlocked using the
remote transmitter.
NOTE: The Green/Black/Red/ Green/& Red/Black wires MUST be connected to their respective source
before powering up the module as these wire are polarity learn and will not function properly if connected
after power up. In addition, these wires if not used as indicated above must be connected to ground.
This will insure proper operation and prevent inadvertent arming and disarming when unintended.
BLUE WIRE : TRUNK TRIGGER SHUNT INPUT
This wire will determine if the vehicle’s trunk has been opened using the OEM transmitter, and prevent the
alarm from triggering when the transmitter is used. This wire requires a positive trigger input and must be
wired to the switched + 12 volt trunk control wire from the vehicle's keyless entry unit or, the switched + 12
volt side of the vehicle's trunk release solenoid.
WIRING THE ARM / DISARM INPUTS IN VEHICLES WITH REMOTE
FEATURE SELECTION 11 SET FOR AND
This appllication is for vehicle's that have a 2nd unlock unavailable or diffi cult to access.
GREEN/BLACK WIRE: ARM INPUT #2
Connect this wire to the vehicle's Parking light wire providing the parking lights are active when the transmitter
is used to lock the vehicle doors.
RED WIRE: DISARM INPUT #1
Connect this wire to the driver's door unlock motor wire, which will receive a negative or positive pulse when
the drivers door is unlocked with the remote transmitter.
GREEN WIRE : ARM INPUT #1
Connect this wire to the driver's door lock motor leg wire, which will receive a negative or positive pulse when
the doors are locked using the the remote transmitter.
RED w/BLACK TRACE WIRE : DISARM INPUT #2
Connect this wire to the vehicle's Parking light wire providing the parking lights are active when the transmitter
is used to lock the vehicle doors.
BLUE WIRE : TRUNK TRIGGER SHUNT INPUT
Please follow information listed above for this wire connection and operation.