Installation Manual

128-9324
9 of 12
Page 9
WIRING THE ARM / DISARM INPUTS IN VEHICLES WHEN THE SYSTEM IS SET UP AS A
STAND ALONE PASSIVE (IGNITION CONTROL) ALARM SYSTEM
For this mode of operation, be certain to set selectable features #5 for passive, #7 for delay, and #8 for 1 wire disarm.
GREEN/BLACK & GREEN WIRE: ARM INPUTS
Connect these wires to chassis ground.
RED WIRE : DISARM INPUT #1
Connect this wire to an ignition source that has +12 volts when the ignition switch is turned to the on and start positions
and has 0 volts when the switch is in any other position.
RED w/BLACK TRACE WIRE: DISARM INPUT #2
Connect this wire to chassis ground.
BLUE: TRUNK SHUNT INPUT
This wire is not used for the stand alone passive alarm application.
VALET SWITCH:
Plug the 2 pin connector from the push-button valet/LED switch into the mating 2 pin connector on the control module.
LED: Plug the 2 pin connector from the push-button valet/LED switch into the mating 2 pin connector on the control
module.
PROGRAMMING (ALARM FEATURES):
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Siren Chirps).
3) Turn the ignition key off then on. (Siren Short Then long Chirp)
4) Press the pushbutton switch once to advance to feature 1, twice to advance to feature 2, etc,,,then use
the lock button of the factory transmitter, or the lock switch on the door to select the feature setting.
Example to set passive arming:
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Siren Chirps).
3) Turn the ignition key off then on. (Siren Short Then long Chirp)
4) Press the pushbutton switch six times to advance to features 6, Pass/Act Arm, then use the lock button
of the transmitter to select two chirps "Passive Arm".
5) To exit the programming mode, turn the ignition key off. The program mode is automatically exited when
there is no activity on the pushbutton switch or the factory transmitter or in vehicle lock switch.