Owner's Manual

128-9323
4 of 8
 1. IftheLEDisashingonetime...pause...onetime...pause...etc.,thenanintrusionattempt
was made to a voltage sensing, light activated entry point, or to an optional sensor that
has been connected to zone 1.
 2. IftheLEDisashingtwotimes...pause...twotimes...pause...etc.,thenanintrusionattempt
was made to the hood or trunk, or to an optional sensor that has been connected to zone
2.
 3. IftheLEDisashingthreetimes...pause...threetimes...pause...etc.,thenanintrusion
attempt was made through one of the vehicle’s doors. These intrusion warning indicators
are stored in the system’s memory, and will only be erased when the ignition key is turned
to the “ on “position.
OPERATING THE EMERGENCY PANIC:
The buttons on your keychain transmitter will allow you to immediately activate the alarm in
emergency situations. To use the remote panic switch;
1. Press the unlock, then lock, then unlock buttons on your keychain transmitter within 3
seconds. The alarm will immediately sound, and continue to sound for 30 seconds.
2. To stop the alarm before the 30 second cycle has expired, simply press and release the
unlock button on your keychain transmitter.
USING THE VALET SWITCH :
The valet switch allows you to temporarily bypass all alarm functions, eliminating the need
to hand your transmitter to parking attendants or garage mechanics. When the system is in
valet mode, all alarm functions are bypassed, however the remote panic feature and remote
doorlockswillremainoperational.Tousethevaletmode,thesystemmustrstbedisarmed
either by using your keychain transmitter, or by overriding the system as explained in the
ManualOverrideSectionofthismanual.
TO ENTER THE VALET MODE:
1. Disarm the unit by use of the factory transmitter or by use of the manual override
sequence.
2. Turn the ignition switch to the “On” position.
3. Press and hold the valet/override pushbutton switch for 5 seconds. The LED
turns on, indicating valet mode has been successfully entered.
TO EXIT VALET:
With the ignition switch in the on position, press and release the valet/override pushbutton
switch one time. The LED turns off indicating the valet mode has successfully been exited.
MANUALLY OVERRIDING YOUR SYSTEM:
USING SIMPLE VALET SWITCH MANUAL OVERRIDE
If your factory transmitter is lost, broken, or otherwise rendered inoperable your Security
System can be disarmed without the use of the keychain transmitter. This is necessary, since
you will need the ability to operate your vehicle if the transmitter is lost or its battery fails. If
your system has been selected for Valet Switch manual override as indicated on the last page
of this manual, to override the alarm system;
Page 4