Owner's Manual

128-9323
5 of 8
Page 5
1. Open the vehicle door. The alarm will sound.
2. Turn the ignition key to the on position.
3. Within 5 seconds, press and hold the valet pushbutton switch.
The alarm system will stop sounding and enter the (bypassed) mode. You can now start
and operate the vehicle normally.
Typically this override mode is used only if the transmitter has become inoperative.
USING CUSTOM CODE MANUAL OVERRIDE:
If your factory transmitter is lost, broken, or otherwise rendered inoperable, your system can
be overridden allowing operation of the vehicle. The manual override code is pre-programmed
at the factory to 11. This code can be changed by the operator to a more familiar two digit
number. Once you’ve become familiar with the system’s operation and override procedure,
we suggest you change the code for added security.
NOTE: The override procedure below describes use, assuming that the factory preset code
has not been changed and is still set to the factory default 11. The valet/override push button
switch is used to enter the tenths and units digits, pressing and releasing this button one time
for each digit required.
If your system has been selected for Custom Code manual override as indicated on the last
page of this manual, to bypass the alarm system; with a code of 11, follow the sequence
listed below:
 1. TheLEDisashingindicatingtheunitisarmed,enterthevehicle,thesirenwillsound,
turn the ignition switch to the “on” position.
2. Within 10 seconds begin to enter tenths digit of override code. (In this ex-ample the code
is 11, so press and release the Valet/Override pushbutton one time).
3. Within 10 seconds of entering the last tenths digit, turn ignition “off then on”.
4. Within 10 seconds of turning the ignition switch on, begin to enter units digit of override
code. (In this example the code is 11, so press and release the Valet/Override pushbutton
one time).
5. Within 5 seconds after the last units digit is entered, turn the ignition switch off, then on,
and start your vehicle.
If the manual override code is entered properly, the unit stops sounding, the LED turns off,
indicating a successful override. The system is now disarmed and you can start and operate
your vehicle. The unit will allow three attempts to disarm via the manual override sequence.
If the code is not successfully entered within the three attempts, disarming with the manual
override switch will be locked for 10 minutes.
In many cases, to increase the security of your system, you may elect to change the manual
override code to a number that is more familiar to you, or simply to have a different code
than was pre-assigned from the factory. To Change the pre-assigned override code follow
the steps outlined below.
It is advised you read both sections under the headings “Programming Your Custom Override
Code” and, “Custom Code Programming Example”, To completely understand the procedure
before beginning: